StetSom Venom V 1000.5 User manual

Phone: [phone] - www.stetsom.com - [email protected]
NOT TURN ON:
- The cables are not correctly connected (terminals BAT, GND and REM). Make sure that all connections
has mechanical and electrical contact.
- Fuses/circuit breakers (external) are defective or burned. Take care about the correct value of the
new fuse!
NO SOUND:
- The cables of speakers or plugs RCA are not connected correctly.
- Check if the LEVEL control is not in the minimum.
NO SOUND / RED LED (PROTECTION) ILLUMINATED:
- Speakers or cables (damaged), so, check speakers, cables and connections.
- Check the battery charge.
BAD SOUND QUALITY (DISTORTION):
- The speakers are overloaded, so, decrease the level and redo the gain adjustment (see iten 2/general
description).
WEAK BASS:
- Cables of speakers (+) and (-) are changed, speakers out of phase (see iten 5/general description).
HOW TO ACT IN CASE OF PROBLEMS
SPECIFICATIONS
VENOM LINEVENOM LINEVENOM LINE
USER’S GUIDE
MODEL: V 1000.5 - STEREO V 1000.5 - MONO
Channels: 4 1
Power @ 13.8V 2 Ohms: 4x100 Watts RMS 1x625 Watts RMS
Power @ 13.8V 4 Ohms: 2x200 BRIDGE Watts RMS 1x450 Watts RMS
Minimum Output Impedance 2 Ohms 2 Ohms
Input Impedance: 15K Ohms
Minimum Sensitivity: 0,2V
Total Harmonic Distortion: < 0,9 % THD
Signal to Noise: > 90 dB
Crossover HIGH PASS: 70Hz to 700Hz
Crossover LOW PASS: - 50Hz to 20KHz
Freq. Response (-3dB) @ 2 Ohms: 20 Hz to 22 KHz 20Hz to 20KHz
Power Tension: 9 to 15V
Consumption Signal Musical: 1,5 to 45A
Consumption Signal BASS: 1,5 to 90A
Dimensions (A x L x C): 40x240x365 mm
Weight: 3,0 Kg
All manuals and user guides at all-guides.com
all-guides.com

INSTALLATION OUTPUT OF SPEAKERS
The amplifier can work with 3 or 5 independent channels the speaker impedance varies from 2 to 4
ohms according to the chosen mode. Be aware of the correct polarity when installing the speakers.
The speaker power must be at least the same as the power delivered by amplifier channel. Notice that
the power output is stronger in 2 Ohms speakers and weaker in 2 Ohms speakers. When using the BRIDGE
connection, the power will also be stronger than in stereo mode. Use 4 mm² gauge cables with up to 3m length.
5 CHANNELS MODE
3 CHANNELS MODE (BRIDGE)
AUDIO INPUT AND CONTROLS
OVERVIEW
OUTPUT AMPLIFIED AUDIO AND POWER INPUT.
All manuals and user guides at all-guides.com