Steve Silver HE500PT User manual

HE500PT
ASSEMBLY INSTRUCTIONS
P. 2/5
STEP 1
Step 2: Attach Mounting Plate A (D) to Leg Frame (C) by using Long Bolt (1), Lock Washer (3), Flat Washer (4). Tighten
with Wrench (5). Repeat to attach remaining piece of Mounting Plate A (D) to Leg Frame (C).
Step 1: Turn Table top (A) upside down on the floor with a piece of cloth or carpet underneath to prevent finish from
scratching. Attach Mounting Plate B (E) to Table top (A) by inserting Long Bolt (1), Lock Washer (3), Flat Washer (4) into
holes on Mounting Plate B (E) and wooden glide, secure with Wrench (5)
Step 3: Attach Mounting Plate A (D), Leg Frame (C) to Table Top (A) by inserting Long Bolt (1), Lock Washer (3), Flat
Washer (4) into holes on wooden glide. Tighten with Wrench (5).
1
3
4
5
1
3
4
5
1
3
4
5
A
E
D
C
STEP 2
STEP 3

P. 3/5
HE500PT
ASSEMBLY INSTRUCTIONS
ON
OFF
Step 5: Turn the table to the upright position. Unlock the latch underneath of the Table Top(A). Pull the Table Top(A) from
both ends, place Leaf (B) in position. Lock the latch underneath of the table top to prevent from sliding. Assembly product is
now completed.
Step 4: Attach Stretcher (F) by securing position G of Stretch (F) to Mounting Plate B (E) and position H to Leg Frame (C)
with Short Bolt (2), Lock Washer (3), Flat Washer (4) and Wrench (5).
G
H
2
3
4
F
B
STEP 4
STEP 5

P. 4/5
(A)TABLE TOP (1PC)(C) LEG FRAME (2PCS)
PARTS LIST
HARDWARE PACK # : PHE500PTH
20PCS
NO. DESCRIPTION DIMENSION Q' TY
Ø5/16 "x1-1/2" 4PCS
(D) MOUNTING PLATE A
(2PCS)
LONG BOLT
LOCK WASHER 24PCS
Ø5/16"x13MMx1.2MM
FLAT WASHER 24PCS
Ø5/16" x19MMx1.8MM
WRENCH 1PC
(B)LEAF (1PC)
(F) STRETCHER
(2PCS)
Ø5/16"x2"
SHORT BOLT
GH
(E) MOUNTING PLATE B
(1PC)
Note: Philip Screwdriver needed but not supplied