Steve Silver Brisbane BS850CG User manual

Item#: BS850CG
Description: Brisbane Power Lift
Chair w/ 3 Zone Heat
00323A(VN)
Product Size: 35.5'' x 42'' x 44.5''H

Page 2
ASSEMBLY INSTRUCTIONS
BS850CG
CAUTION:
STEP 1:
Back Receivers
Steel
Mechanism
Post
Figure A
Figure B
Screwdriver required (not included)
Attached to the top of the swivel base is the hardware bag that includes the power transfor
-mer, power cord and power transformer extension cord. Remove the parts from the bag and
attach the power cord to the transformer and the power transformer extension cord to the
matching end coming from the power transformer. Make sure to close the clip lock to prevent
the connection from coming loose during use. Set the assembly aside to be used in step 5.
STEP 2: Attaching the Recliner Back: Position the KD back(A) with the KD receivers positioned over
the mechanism post on the recliner body (B) as pictured below. Check to assure both sides
of the mechanism post are positioned inside of the KD receivers on the back frame, push in
a downward motion from the top of the back frame until a clicking sound is heard.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING ASSEMBLY PROCESS. IT IS
RECOMMENDED TO USE TWO PEOPLE WHEN ASSEMBLING AND REMOVING THE INSIDE BACKS
TO AND FROM THE BASE OF THE FURNITURE.
Transformer
and Cord
HEAT
BACK
HEAT
HEAT
HEADREST

Product Size: 33.1” ×30.3” × 33.5”H
Page 3
STEP 4:
STEP 3:
STEP 5: Attach the outside back across the bottom rear of each seat rail with the pre attached Velcro.
The headrest leadwires are color coded and labeled Headrest.
The headrest leadwires are yellow.
Attach the leadwires found at the bottom of motion back to the leadwires at the rear of seat.
Yellow to Yellow. Make sure to close the clip locks to assure the connections will not come
loose during use.
Slide the metal inserts on recliner’s Left wing(C)and Right wing (D) into the metal sleeves on
the side of the recliner’s back. Slide the wings down until they are completely set on the backs
metal sleeves.
C
D

Page 4
TOOLS REQUIRED : NO TOOLS REQUIRED
PART LIST
NO Description Sketch Quantity
PBS850CGT
PBS850CGP
1
1
1
A
B
CPBS850CGS

Page5
PRODUCT DETAILS
RECLINER CHAIR BODY
PRODUCT SIZE
CARTON SIZE
SEAT HEIGHT
SEAT DEPTH
NET WEIGHT
GROSS WEIGHT
CU.FT.
STEEL+PLYWOOD
L 37" × W 30.75" × H 33.5"
24.8"
20.5"
162.8 LBS
177.1 LBS
22.06
Spare part for BS850CG
PBS850CGT PBS850CGP PBS850CGS
FABRIC CONTENT: POLYESTER 100%
FABRIC CONTENT: POLYESTER
FRAME MATERAL: WOOD & IRON
FABRIC CLEANING CODE : S
USER MANUAL : SOLVENT AND / OR WATER BASED CLEANERS
This fabric is not machine washable.
Allow+/-3% residual shrinkage.
Do not use cleaning products containing brightening agents
L 35.5" × W 42" × H 44.5"