STI-CO FILM-NB-GPS User manual

ci-321 Page 1of 2REV 000
a2002 STI-CO INDUSTRIES, INC., 11 Cobham Drive, Orchard Park, NY 14127-4187
Technical Support: E-mail: [e-mail] Phone: [phone] Fax: [phone]
Made in U.S.A.
Antenna Mounting Instructions
FILM-NB-GPS
INSTALLATION USING FILM ANTENNA MOUNTED ON GLASS:
1. Use alcohol swipe to clean dirt and dust particles from glass surface.
2. Install with glass above 65° F. so film does not appear cloudy.
3. Mount on glass between 1/8” -1/4" (4-6mm) thick.
4. Refer to Figure 1-Antenna Placement
5. When choosing placement, leave room to attach amplifier.
Note: Film antenna must be kept at least 2” away from metal. Orientation of antenna is not critical.
6. Remove adhesive backingfrom film using pull-tabs. Avoid getting fingerprints on adhesive.
7. After adhering film to glass, press out any air bubbles.
8. Remove top film protecting the antenna contact points.
9. Peel backing tape from amplifier using pull-tabs.
10. Line up amplifier terminal pointswith the points on the film. (Figure 2)
11. Apply pressure for 20-30 seconds. Adhesive cures in 5-10 minutes.
Figure 2 –GPS Film Antenna
INSTALLATION USING DURABLE RE-
USABLE PLASTIC CARD:
1. Remove protective film from plastic card before
attaching antenna.
Figure 1 –Antenna Placement

ci-321 Page 2of 2REV 000
a2002 STI-CO INDUSTRIES, INC., 11 Cobham Drive, Orchard Park, NY 14127-4187
Technical Support: E-mail: [e-mail] Phone: [phone] Fax: [phone]
Made in U.S.A.
2. Use figure 3 as a transparent template for correct antenna placement on plastic card.
3. Remove adhesive backing from film using pull-tabs. Avoid getting fingerprints on adhesive.
4. After adhering film to card, press out any air bubbles.
5. Remove top film protecting the antenna contact points.
6. Peel backing tape from amplifier using pull-tabs.
7. Line up amplifier terminal points with points on the film (Figure 4).
8. Apply pressure for 20-30 seconds. Adhesive cures in 5-10 minutes.
9. Use with or without adhesives. (not supplied) for temporary mounting.
Antenna is notweather resistant.
Figure 3
-
GPS Film Antenna Template
Figure 4 Plastic Card Installation