STI-CO FILT-NB-UHF-COM-MF User manual

CI-520 Page 1 of 2 REV 000
2021 STI-CO INDUSTRIES, INC., 11 Cobham Drive, Orchard Park, NY 14127-4187
Technical Support: E-mail: techsuppor[email protected] Phone: [phone] Fax: [phone]
Made in U.S.A.
Installation Considerations
FILT-NB-UHF-COM-MF 450 MHz PASSBAND
FILT-NB-UHF-COM-N 450 MHz PASSBAND
VERIFY FOR FILT-NB-UHF-COM-MF:
1. Part List:
PART NUMBER
DESCRIPTION
QTY
FILT-NB-UHF-COM-MF
FILTER, 450 MHz PASSBAND
1
HK-171
HARDWARE KIT, FILT-NB-160-MIL-X
1
2. Bandwidth: The filter has a 10 MHz bandwidth and is designed to operate from 450 to 460 MHz.
VERIFY FOR FILT-NB-UHF-COM-N:
1. Part List:
PART NUMBER
DESCRIPTION
QTY
FILT-NB-UHF-COM-N
FILTER, 450 MHz PASSBAND
1
HK-171
HARDWARE KIT, FILT-NB-160-MIL-X
1
2. Bandwidth: The filter has a 10 MHz bandwidth and is designed to operate from 450 to 460 MHz.

CI-520 Page 2 of 2 REV 000
2021 STI-CO INDUSTRIES, INC., 11 Cobham Drive, Orchard Park, NY 14127-4187
Technical Support: E-mail: techsuppor[email protected] Phone: [phone] Fax: [phone]
Made in U.S.A.
INSTALLATION:
1. Select the location of the filter, the area should be free of obstructions and allow for cables to be easily
routed to the filter.
2. Mark the pilot holes to be drilled by using the filter as a template.
3. Attach the filter to the bulkhead by pre-drilling four holes with a #21 (0.159”) drill bit, then secure in place
using the hardware provided.
4. Connect the cable from the antenna to the port marked ANTENNA.
5. Route the cable from the transceiver equipment and connect to the port marked RADIO.
6. Avoid installing cable near any sharp edges that may cause damage due to vibration.