Stihl TS 700 User manual

04-015
1
04-015
14” CUT-OFF SAW
Gas Powered Stihl 700
PROCEDURES:
•Unit will be sent with 50:1 gas mixture, wrench and goggles.
•Use only in well ventilated areas. Gas fumes are hazardous!
•Area must be clear of any debris before cutting.
•Determine what type of material is to be cut. Asphalt, concrete, metal and ductile blades are
available. 6300 rpm or faster are required.
•Blades must have a 20mm arbor.
•SHUTDOWN: Allow engine to idle down approximately 5 minutes to reduce engine heat
from burning protective coating of oil in cylinder.
•Customer should clean air filter after every four hours of usage.
•Customer will be instructed on proper filter and gasket combination. Exploded view diagram
provided on back of page.
•Consult owner’s manual for changing position of blade.
•Customer will be charged for any clean up or damage due to neglect.
SPECIFICATIONS:
2 Cycle Engine
9,800 RPM
50:1 Mixture
6.1 Cu In. - 6.7 bhp
Fuel Capacity: 26.2 oz.
Depth: 4.9”
Arbor: 20 mm
Weight: 26.2 lbs

04-015
2
Troubleshooting:
If the unit does not start:
1. Check to make sure the filter is not completely plugged with concrete dust.
2. Check fuel level.
3. Remove and clean spark plug. Pull start unit without spark plug to remove any excess
fuel from cylinder.