Stoll Essential Build-out Kit Operation manual

Essential Build-out Kit
Assembly & Installation
Installation & User Guide
Installer please leave this with homeowner

A. Self Tapping Screws
B. Face Panels: 2
C. Vertical Supports: 2
D. Horizontal Brackets: 3
E. Rear Mounting Bracket: 1
F. Top Cap/Shelf
A.
Thank You!
Thank you for purchasing a Stoll Fire Build-out Kit! We are condent this
quality product will last you for years to come. If you need further help or
additional information regarding installation, please reach out to your local
dealer for assistance.
Included Parts & Tools

Shell Assembly
Lay the face panels (b) face down on a soft/non-abrasive surface to ensure they do not
scratch.
Using the provided self-tapping screws, attach the face panels together. Screw hole
locations are pre-drilled in each panel to ensure proper alignment.
Build-out Kit Assembly
Standing the face panels upright, connect both vertical supports (c) to the face
panels through the appropriate slots. (Each vertical support has lasercut slots cut that
correspond with cleats on the face panels). Using a rubber mallet, ensure cleats are fully
seated in the corresponding slots.

Shell Assembly continued...
In the top corner of each side, fasten the vertical supports in place with the provided self-
tapping screws.
Attach the rear mounting bracket (e) to the top of the vertical supports. Insert the cleats
through the corresponding slots, and secure in place with the provided self-tapping
screws.

Shell Assembly continued...
Attach the three horizontal supports to the corresponding slots and cleats on the vertical
supports behind the face panels. Two bars attach to the front of the vertical supports
above and below the opening, and one to the back of the vertical supports below the
opening. The two lower brackets will overlap.

Firebox Installation
Following the manufacturers installation instructions for your specic rebox, install the
rebox into the build-out kit.

Mounting
If desired, attach the build-out kit to the wall or structure behind it by a securing it
through the rear mounting bracket with the appropriate fasteners (not included).
Shelf Assembly
Attach the top cap/shelf (f) to the build-out kit by aligning the cutouts on the back of the
shelf with the vertical supports, and sliding it down into place.

This product can expose you to chemicals
including Carbon Black, which is known to
the state of California to cause Cancer.
For more information go to
www.P65Warnings.ca.gov
• Your Build-out Kit can be cleaned using a damp cloth and soap or mild household
cleaner, or rubbing alcohol for tougher stains. To avoid damage to the nish, abrasive
cleaning products and cleaners containing ammonia or other harsh chemicals should be
avoided.
Operation & Maintenance
Warranty
Your Build-out Kit is covered by a 3 year limited warranty. For more information, please
visit www.stollindustries.com/resources. All warranty claims must be placed through your
local dealer.
Photos of Completed Products
We would love to see pictures of your nished and installed project! Please send images to
[e-mail]. High quality images will likely be featured on our social media
or website!