Fitting Instructions for Arcisan Mirror
132
DIMENSIONS
X&Y
Ø6
1. Handle with care. When unpacked, never place mirror upright on a
hard surface e.g. Tile Floor. Always lay on soft surface.
2. Drill 2 holes on wall surface as per diagram 1 to desired
height.64”from oor to centre of mirror is advised but may be
adjusted as required, Use spirit level to ensure holes are level. If
drilling through tiles, use a ceramic drill bit.
3. Inset rawl plugs into holes and screws into holes.
4. Attach wire from back of mirror to mains wire in accordance with
current IEE regulations. A second person will be needed to hold the
mirror in place.
5. Hang the mirror onto the screws via holes in the frame.
6. Some mirrors may be hung portrait or landscape.
7. Adistance of 80 mm is necessary between the sensor switch and
any other object in any direction
8. Enjoy!
This mirror is suitable for Zone 2 or higher and not Zone
0 or 1 (see diagram)
We advise that you consult a qualied electrician for the
installation.
Switch off electrical supply at mains before tting.
Ensure wall surface is of suitable strength and
construction.
Beware of hidden cables or pipes.
For plasterboard walls, specialist xings should be
purchased from DIY or hardware stores.
The mirror is heavy so you may need assistance.
Turn lights on/off using infra red sensor -leave off when
not in use.
Heat pat turns on with light switch and takes 2/3 minutes
to heat up.
FITTING INSTRUCTIONS GENERAL INFORMATION
Thanks for purchasing an Arcisan mirror. For safety reasons,we kindly ask you to read
this installation and user guide carefully before you install and use the product.
X
Ø8
Y
X
X
1 - Long press on left key, clock enters in setting up mode.
First number starts flashing. Press the right key to choose
numbers, 1 or 2.
2 - In setting mode, short press on left key, choose number
position to adjust,then press right key to choose the number.
