StreetStrider Indoor Trainer Stand User manual

INDOOR TRAINER STAND
ASSEMBLY GUIDE
1-800-348-0998 | www.StreetStrider.com

2
PART # DESCRIPTION QTY
1Main frame 1
2Side Stabilizers, Right and Left 2
3Roller Assembly 1
4L-rod and Knob 1
5Podium with Top Cradle and Draw Clamp, Right and Left 2
6Front Wheel Riser Blocks 2
7Rubber Leveling Feet 3
870 x 6 mm Hex Head Bolts with 13 mm Lock Nuts 4
965 x 6 mm Hex Head Bolts with 13 mm Lock Nuts 2
10 Carriage Bolt with 13 mm Lock Nut 1
PARTS LIST (Note – Right and Left refer to sides when standing on the StreetStrider.)

3
1
2
3
4
5
6 6
7
8
9
10
7
7

4
STEP 1
STEP 2
STEP 4
STEP 3
STEP 5
Slide each stabilizer into main frame and secure with
65 x 6 mm hex bolt and 13 mm lock nut.
Flip trainer over and screw in 3 rubber leveling feet.
Slide L rod into frame tube. Mount roller assembly in frame
and secure with carriage bolt and 13 mm lock nut.
Raise roller assembly so that L rod protrudes through rear
hole, slide washer over threaded end and screw on knob.
With trainer sitting on rubber feet, mount Right and Left
podium on square cross bar about 2 inches apart. Secure
with the 70 x 6 mm hex bolts and 14 mm lock nuts.

5
To mount the rear frame onto podium cradles, rotate
cradles so that the 45° lip is toward the outside.
STEP 6 - 3i and 7i StreetStrider STEP 7 - 3i and 7i StreetStrider
To mount the rear frame onto podium cradles, rotate
cradles so that the 45° lip is toward the inside.
Set chain stay in cradle about 1 inch in front of drop out.
Lay the 3i shifter cable in cradle next to frame. The 7i shifter
cable will be under the cradle. Adjust nuts on lower end of
draw clamp to secure frame when clamps are pressed down.
STEP 6 - 3r, 8r and Eclipse STEP 7 - 3r, 8r and Eclipse
Set chain stay in cradle about 1 inch in front of drop
out. Shifter cable and chain will not touch inner edge
of podium. Adjust nuts on lower end of draw clamp to
secure frame when clamps are pressed down.
Shifter cable in cradle
Adjust draw
clamp nuts
Adjust draw clamp nuts

6
STEP 8 STEP 9
Screw L rod knob in at rear of roller assembly to
press roller against tire.
STEP 10
ASSEMBLED TRAINER STAND
Front wheel riser blocks can be used to help stabilize
the front wheels.
Screw in resistance knob on side of roller assembly to
increase resistance. Resistance can also be increased by
shifting to a higher gear while riding.

7
OUTDOORS + INDOORS

1-800-348-0998 | www.StreetStrider.com