HOW TO USE YOUR BLASTER BRUSH
lMix car shampoo and warm water in a bucket to generate plenty of foam.
lConnect your Blaster Brush to a garden hose with (standard) hose connector (1).
Ensure water flow is OFF (2).
lTwist (3) and adjust the telescopic pole to the desired length and re-tighten to secure.
lTum on the tap and set the switch on your Blaster Brush to ON (2). Spray away surface dirt,
debris and grime.
lSwitch OFF (2). Dip the brush in soapy water and wash your car (or other item) one section at a
time, working from the top, down. Wash the tyres and rims last.
lAfter washing each section, immediately switch ON (2) for a blasting rinse to avoid soapy streaks.
TiPS FOR THE PERFECT WASH EVERY TIME
lDo not clean with very hot water as this may damage the bristles.
lOnly use a quality high foam car shampoo - and use plenty!
lAvoid cleaning with dishwashing liquid or detergent.
lBefore use, it is essential to ensure bristles are FREE from grit to avoid scratches.
lAvoid leakage by ensuring all parts are securely screwed together before
turning on the tap.
lAvoid using water pressure that is too high.
lAlways give the car a blasting rinse first before brushing.
lAfter use, rinse bristles thoroughly under running water to remove excess soap.
lStore standing upright to avoid bristle damage. Make sure switch is set to ON.
Read and understand
these instructions
before attempting any
operation of this Blaster
Brush and retain for
future reference!
SWCWB5 &
SWCWB5CB
1
2
3
SWCWB5-Manual.qxp_Layout 1 19/03/2018 08:01 Page 2