Stryker WiSe 0240030972 User manual

WiSe™ HDTV Receiver
User Guide
0240030972
WiSe™ HDTV Receiver

Table of Contents
1 Warnings and Cautions
3Symbols
3Product Description
3Intended Use
4 Indications and Contraindications
4Package Content
5Device Features
5Front Panel
5Rear Panel
6Setup
6Connecting AC Power
6Wall Mount Adapter Mounting Options
7Routing Video Conguration Setup #1
9Routing Video Conguration Setup #2
10 Instructions for Use
10 Link the Transmitter to the Receiver
11 Cleaning
12 Troubleshooting
13 Technical Specications
14 Electromagnetic Compatibility

EN-1
Warnings and Cautions
Please read this manual and follow its instructions carefully. e words warning, caution, and note carry special
meanings and should be carefully reviewed:
Warning e personal safety of the patient
may be involved. Disregarding this
information could result in personal
injury.
An exclamation mark within a triangle is
intended to alert the user to the presence
of important operating and maintenance
instructions in the literature accompanying
the device.
Caution Special service procedures or
precautions must be followed to avoid
damaging the device.
A lightning bolt within a triangle is intended
to warn of the presence of hazardous voltage.
Refer all service to authorized personnel.
Note Special information to make
maintenance easier or important
information more clear.
Warnings
To avoid potential serious injury to the user and the patient and/or damage to this device, please note the following
warnings:
• Read the operating manual thoroughly and be
familiar with its contents prior to using this device.
• Carefully unpack the device and check if any
damage occurred during shipment.
• Test this device prior to a surgical procedure.
is device was fully tested at the factory before
shipment.
• Do not put any liquid into the device. If this occurs,
unplug the device and have it checked by qualied
personnel before operating it any further.
• Avoid disassembling any part of the WiSe HDTV
Receiver or the WiSe R1-R2 adapter cover, as doing
so may break the seals, causing leakage and/or
electric shock.
• Avoid removing the WiSe HDTV Receiver or the
WiSe R1-R2 adapter cover, as doing so may cause
damage to electronics and/or electric shock.
• Ensure that the electrical installation of the relevant
operating room complies with NEC and CEC
guidelines.
• Do not attempt internal repairs or adjustments
not specically detailed in this operating manual.
Ensure that readjustments, modications, and/or
repairs are carried out by persons authorized by
Stryker Endoscopy.
• Use appropriate caution to prevent contact with
uids if the device is being used with a power
supply in patient environments.
• Federal law (Deviceed States of America) restricts
this device to sale by, or on the order of, a
physician.
• Ensure the device is mounted securely. Damage to
the device or personal injury can occur if the device
is not installed as instructed.

EN-2
Cautions
• Plug the AC adapter into a grounded power outlet.
• Use only the proprietary power supply. Completely
secure the connection between the DC power cord
and the extension cord.
• To connect to an international power supply, use an
attachment plug appropriate for the power outlet.
• Power o the device when it is not in use.
• Remove the power module and connection when
transporting the device.
• Unplug the device if it is not to be used for an
extended period of time.
• Never operate the device immediately aer
transportation from a cold location to a warm
location.
• Pay close attention to the care and cleaning
instructions in this manual. A deviation may cause
damage.
• Do not expose the WiSe HDTV Receiver console
to moisture. Spray the cleaning solution into a so
cloth and clean gently.
• Do not sterilize the WiSe HDTV Receiver console,
as the delicate electronics cannot withstand this
procedure.
• Allow adequate air circulation to prevent internal
heat buildup. Do not place the device on surfaces
(rugs, blankets, etc.) or near materials (curtains,
draperies) that may block the ventilation slots. e
WiSe HDTV Receiver console is cooled by natural
convection and has no fan.
• Do not install the device near sunlight or excessive
dust.
• Do not touch the patient with signal input or
output connectors. Equipment with SIP/SOP
connectors should either comply with IEC60601-
1 and/or IEC 60601-1-1 harmonized national
standards or the combination should be evaluated
for safety.
• To ensure electromagnetic compatibility, refer
to the “Electromagnetic Compatibility” section
of this manual. e WiSe HDTV Receiver
(REF#0240030972) must be installed and operated
according to the EMC information provided in this
manual.
• e WiSe HDTV Receiver (REF#0240030972) has
been tested under the UL 60601-1 standard and
is UL listed for medical application. e warranty
is void if any of these warnings or cautions are
disregarded.
• Changes or modications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the device.
Note: is device has been tested and found to
comply with the limit for a Class B digital device,
pursuant to Part 15 of the FCC Rules. ese limits
are designed to provide reasonable protection against
harmful interference in a residential installation.
is device generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. ere is
no guarantee that interference will not occur in a
particular installation, which can be determined by
turning the device o and on. e user is encouraged
to try to correct the interference by one of the
methods listed in the Troubleshooting section under
the listed possible cause, “Interference.”

EN-3
Symbols
e following symbols appear on the device, its labeling, or the device packaging. Each symbol carries a special
denition, as dened below:
Direct Current IPX0 Degrees of protection against the ingress of
water
Wireless Transmission For physician use only
Tested to comply with FCC Class B standards Protection against electrical shock - Class II
Denotes compliance to CAN/CSA C22.2 No
601.1-M90 UL60601-1 Read Instructions for Use
Operating Humidity Ratings European Authorized Representative
Operating Temperature Ratings Serial Number
For indoor use only Reference Number
Fragile Manufacturer
is symbol indicates that the waste of
electrical and electronic equipment must not
be disposed as unsorted municipal waste and
must be collected separately. Please contact
the manufacturer or other authorized disposal
company to decommission your device.
Made in the USA
Product Description
e WiSe HDTV Receiver (Receiver) is an extension of the WiSe HDTV System and uses a radio frequency (RF)
link to receive high denition video and remote signals from the WiSe HDTV Transmitter (Transmitter). e
Receiver has one DVI and two remote outputs which allow it to be used with the Stryker Digital Capture (SDC)
device and Stryker surgical viewing displays with DVI input. It uses the same wireless technology as in the WiSe
HDTV System. e Receiver has a bi-color LED for device status, the same token and token slot as the current WiSe
HDTV system, compact wireless router style design with multiple placement options, and simple mode of operation.
e R1-R2 adapter (Optional Accessory) will be used on the Transmitter side to accept R1 and R2 cable connections.
Intended Use
e WISE HDTV Receiver, when connected with the compatible Stryker monitors/DVI devices, is intended for
wireless video display during surgical procedures including arthroscopy orthopedic surgery, laparoscopy (general
and gynecological surgery), thorascopy, endoscopy (general, gastroenterological and ENT surgery), and general
surgery.
e WISE HDTV Receiver, when connected with the SDC, is intended for wireless transfer of image data including
video and remote signal between medical devices (optional).
e WISE HDTV Receiver is a non-sterile reusable accessory not intended for use in the sterile eld. e WISE
HDTV Receiver is intended for use by qualied physicians having complete knowledge of these surgical procedures.

EN-4
Indications and Contraindications
e WiSe HDTV Receiver, when connected with the Stryker display(s), as an accessory to the surgical camera, is
intended for visualization during surgical procedures including:
• General surgery
• General laparoscopy
• Nasopharyngoscopy
• Ear endoscopy
• Sinuscopy
• Plastic surgery wherever a laparoscope/endsocsope/arthroscope is indicated for use
• Other endoscopic surgeries including:
Laparoscopic cholecystectomy, laparoscopic hernia repair, laparoscopic appendectomy, laparoscopic pelvic
anterior spinal fusion, anterior cruciate ligament reconstruction, knee arthroscopy, shoulder arthroscopy,
small joint arthroscopy, decompression xation, wedge resection, exible endoscopy, urology, gynecology,
lung biopsy, pleural biopsy, dorsal sympathectomy, pleurodesis, internal mammary artery dissection for
coronary artery bypass, coronary artery bypass graing where endoscopic visualization is indicated and
examination of the evacuated cardiac chamber during performance of valve replacement.
ere are no known contraindications.
Package Content
REF# 0240030972 REF# P11883 REF# P11281 REF# P11139
(1) WiSe HDTV Receiver (1) Base Stand (1) Wall Mount Adapter (1) Wall Mount Plate
REF# P11142 REF# 0105033001 REF# 0105207131 REF# P12866
(1) AC Adapter (1) Hospital-grade
AC power cord
(1) DVI Cable, 3FT (1) R1-R2 Adapter
(Optional Accessory)
REF# P13014 REF# 0105207102
(1) USB A to B Cable
(Optional Accessory)
(2) 6-32 x 5/16" Philips
Pan Split/Flat Washer
Sems
(1) R1-R2 Adapter
(Optional Accessory)
(REF#P12866)
(1) USB A to B Cable
(Optional Accessory)
(REF#P13014)

EN-5
Device Features
e Receiver can be used with the Transmitter (REF#0240030971), which allows it to receive a high-denition video
and remote signals over a radio-frequency link. is link is established by means of the token (REF#0240030974),
which is included with the Transmitter.
Front Panel Rear Panel
3
4
2
1
1
2
3
4
1. Token Status LED Provides feedback when
linking the Receiver and
the Transmitter
1. DC Power Inlet 5 VDC input; connects to
separable hospital-grade
AC power cord that can be
used for mains isolation
2. Token (Included with
the Transmitter)
Initializes the wireless
connection aer
insertion into the
Transmitter and the
Receiver and display
2. DVI Output Connects to SDC or any
other display
3. Token Slot Site of insertion for
the token to establish a
wireless connection
3. Remotes 1 and 2 Connects to SDC
4. Power switch Powers the Receiver ON
and OFF
4. RS232 Port Maintenance port
(not for customer use)

EN-6
Setup
Warning
When the Receiver is used with other devices, leakage currents may be additive. Ensure that all
systems are installed according to the requirements of IEC 60601-1-1.
Always set up the Receiver in a location that allows adequate ventilation. Insucient ventilation
may cause the Receiver to overheat and shut down.
Connecting AC Power
Warning
Always use the hospital-grade AC power cord supplied with the Receiver.
1
23
1. Connect the AC adapter to the 5V input on the Receiver.
2. Connect the power cord to the power supply.
3. Connect to the AC mains using the supplied hospital-grade AC power cord.
Wall Mount Adapter Mounting Options
1. Line up dimple and thru holes.
Orient the Wall Mount Adapter in such a way that the dimple and thru holes line up with the blind hole and
threaded PEMS on the Receiver.
2. Secure the Wall Mount Adapter onto the Receiver console.
Use two 6-32 x 5/16" Phillips Pan Split/Flat Washer SEMS (REF#0105207102) using a Phillips screw driver.