Stuv 3.31.270 Series User manual

www.stuv.de 01
LOCKING SYSTEM OPTIONAL
3.31.270X.X
with pro le-cylinder and 3 keys,
with press and click shut feature
Operation angle 90°
Mounting 10 x Countersunk screw M5
Temperature range -40°C up to +80°C
Cap luminescent
Emergency release integated
Model right hand and left hand version available
Tested up to 200.000 cycles
FEATURES
Date of issue 06/2017 • All speci cations are approximate • Errors and changes excepted • Product photos are for illustration purposes only
Housing, Cap Plastic, dyed
Handle Plastic, dyed
Inside and outside guide Zinc die-casting, plated
Conformity of the materials all materials used are RoHS and REACH compliant
MATERIAL & FINISHING
Available options:
• door thicknesses 80 mm, 90 mm, 100 mm, 120 mm, 125 mm, 140 mm
• Multiple Locking System Optional
MADE
IN
GERMANY
LOCKING SYSTEM OPTIONAL

www.stuv.de 02
ASSEMBLY INSTRUCTIONS
3.31.270X.X
01 Insert the outside guide (Pos.6) into the hole provided for the door and mount it with 4x countersunk head screws M5 to the front of
the door. When doing so, pay attention to the „OBEN“ mark.
02 Insert the inside guide (Pos.5) into the hole of the door and also mount it with 6x countersunk screws M5 to the inside of the door.
When doing so, pay attention to the „OBEN“ mark.
03 Insert the outside handle (Pos.1) vertically into the outside guide (Pos.6).
04 Insert the intermediate ring (Pos.4) over the inside guide (Pos.5) so that the bore in the intermediate ring (Pos.4) is inserted into the
pins of the inside guide (Pos.5).
05 Place the shim disc (Pos.3) on the bearing sleeve (Pos.7) and make sure that the recess of the shim disc (Pos.3) is pointing down-
wards.
06 Insert the inside handle (Pos.2) vertically into the bearing sleeve (Pos.7) and screw it to the outside handle (Pos.1) using the 3x
countersunk screws M6x40 (Pos.8).
07 When screwing the three countersunk screws M6x40 (Pos.8), make sure that all three countersunk screws are tightened evenly.
08 The handle must still be rotatable!
09 Insert the cap (Pos.9) into the inside handle (Pos.2). Make sure that the nose of the cap (Pos.9) is in the corresponding lock and that
the „EXIT“ label is horizontal.
10 Fit the cap (Pos.9) with the at head screw M4 (Pos.10).
ASSEMBLY
SAFETY NOTICE
For safety reasons a second person must be on the outside of the door when testing the emergency
escape function with the door installed
PROFILE CYLINDER REPLACEMENT
When changing the prole half cylinder, make sure that the locking lug is in 90° position (3 o‘clock)

www.stuv.de 03
ASSEMBLY INSTRUCTIONS
3.31.270X.X
Fig. shows right hand version
Inside handle
Recess
Inside guide
Intermediate ring
Shim
Inside handle
Countersunk screw
Cap
Flat headed screw
Shim
Cap
Flat headed screw
Countersunk screw
Intermediate ring
Inside guide
Outside guide
Outside handle
Bearing sleeve

www.stuv.de 04
DRILLING PATTERN
3.31.270X.X
Door Door
InsideOuside
Frame Frame
Inside
Outside
Door
Fig. shows right hand version