
www.ssilocators.com 7
SERIES
WIRELESS INDUCTIVE CLAMP
If, the Wireless Inductive Clamp is not working properly, return it to the factory for repair.
The required return information may be obtained by Phone at:(920) 347.1788, Fax: (920) 347.1791,
Send it prepaid to:
SubSurface Instruments, Inc.
Repair Department
1230 Flightway Dr
De Pere, WI. 54115. USA
NOTE: Contact your freight forwarder for the most up-to-date restrictions and labeling requirements for
products containing Lithium-Ion Batteries.
NOTE: There is a minimum charge for repair and handling. When shipping your instrument, be sure to
include:
1. The name, address, and phone number of your contact.
2. A brief description of the trouble.
3. A return shipping address & billing address & any special shipping instructions.
Packing Instructions:
Place the unit to be repaired in the original shipping carton, or equivalent sturdy container. Add packing
material around all sides of the unit. Seal the shipping container with strong tape. Failure to package the
equipment properly may result in voiding warranty.
Mark the shipping container: FRAGILE ELECTRONIC EQUIPMENT
FCC Compliance Statement
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• The equipment may not cause harmful interference.
• The equipment must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the manufacturer’s instruction manual, may cause harmful interference with
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case you will be required to correct the interference at your own expense.
Industry Canada compliance Statements
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Modifications
Any changes or modifications to this device, not expressly approved by the RYCOM Instruments, Inc. could
void the user’s authority granted by the FCC to operate the equipment.
faCTory serviCe
ComplianCe