Sunlight Supply 738315 Operating manual

10” De-chlorinator System
Product # 738315
20” De-chlorinator System
Product # 738320
SETUP AND MAINTENANCE GUIDE

10” De-chlorinator system includes:
1. Poly Spun Sediment filter – Removes sediment, particulates, dirt, and rust.
2. Coconut Carbon Block filter – Removes chlorine, odor, and other chemicals.
3. Water Source Inlet Tubing, 1/4” (White) – w/ Garden Hose Connector.
4. Filtered Water Outlet Tubing, 1/4” (Blue).
5. Inline shut-off valve.
6. Wall mount bracket.
7. Filter Wrench – for safe removal of filter housing.
WHAT’S IN THE BOX?
2

20” De-chlorinator system includes:
1. Poly Spun Sediment filter – Removes sediment, particulates, dirt, and rust.
2. Coconut Carbon Block filter – Removes chlorine, odor, and other chemicals.
3. Water Source Inlet Tubing, 3/8” (White) – w/ Garden Hose Connector.
4. Filtered Water Outlet Tubing, 3/8” (Blue).
5. Inline shut-off valve.
6. Wall mount bracket.
7. Filter Wrench – for safe removal of filter housing.
3

4
The following steps will get you set up in just a few minutes. Please read
each step carefully. If you have any questions, please refer to our website
at www.IdealH2O.net for information and videos on setup & maintenance.
Step 1 – Connect the tubing to the unit:
Insert the BLUE filtered water outlet tubing into connection marked OUT. (fig. A).
Insert the WHITE water source inlet tubing into connection marked IN. (fig. B).
QUICK OPERATION GUIDE
(fig. B)(fig. A)

5
Step 2 – Starting up your De-chlorinator System:
Connect the white inlet tube to your water supply and slowly turn on the water
source. Once the sediment and carbon filter housings have water in them, turn
the water supply fully on.
RUN
30 - 40
MINUTES
RUN
30 - 40
MINUTES
Always run system 30 to 40 minutes before use,
especially after changing the filters.

6
REPLACING THE PRE-FILTERS
Step 1 – Unscrew the filter housing from the system using
the filter wrench included with your system.
Step 2 – Replace sediment and/or carbon pre-filters.
Step 3 – Screw the filter housing back onto the
De-chlorinator system, firmly hand
tightening these. Do not use the
wrench to tighten.

REPLACEMENT FILTER INFORMATION
7
A
B
C
D
10” DE-CHLORINATOR
REPLACEMENT FILTER
PART
NUMBER
FILTER REPLACEMENT
TIMELINE
ASediment Filter - 10” 738335 6 to 12 months
BCoconut Carbon Filter - 10” 738330 1,000 - 1,500 gallons of clean water
20” DE-CHLORINATOR
REPLACEMENT FILTER
PART
NUMBER
FILTER REPLACEMENT
TIMELINE
CSediment Filter - 20” 738350 6 to 12 months
DCoconut Carbon Filter - 20” 738355 1,000 - 1,500 gallons of clean water

Exclusively distributed by:
www.sunlightsupply.com
For all warranty inquiries, please contact
Ideal H2O™at [phone].
Scan this QR code or visit our website for
how-to videos and other product information.