If someone enters the room again, SUNNYHEAT PresenceControl registers the movement and
informs the infrared heating system. The SUNNYHEAT panel heaters will heat normally to your
wished temperature.
Mounting
The PresenceControl should generally be placed that the motion detector can optimally
overlook the entire room. On the back is already a factory assembly preparation for the wall, so
you can easily position your PresenceControl. You can also put your PresenceControl on a table
or a cabinet.
After attaching your PresenceControl you shoud connect your PresenceControl with the
SUNNYHEAT Infrared heating systems. Therefore, please switch the heating panel, which you
want to connect with the PresenceControl, off and on again. Now it is in the service-mode for 20
seconds. Please take the next step within this time - otherwise you have to repeat the
connection from this step.
Please hold the control element on your PresenceControl until the indicator light blinks. Now
press the control element within 10 seconds briefly again.
If all steps are correct done, the heating panel and the PresenceControl are connected now.
Proof the connection by making a movement, the indicator light should blink or leave the room
for over 30 minutes. Then you can see a little window and the setback temperature on the
screen of your ISTC.
You can choose the setback temperature in the configuration level of your ISTC. By default the
setback temperature is 15°C.
Configure setback Temperature
Please press the second and third button at the
same time. Do this a second time to get to the
configuration level. You can see a tool in the
upper left corner.
Press the second key until you can see the
„tune“-menu on the screen.
Please press the second and the third key at the
same time again to get into the menu.
Press the second key until you can see a little
window. This temperature is the setback
temperature
You can change the setback temperature by
using the arrow-keys.
Press the first key three times to get back to the
main display.
