SUNRAY Rockledge 200LX User manual

MODEL:WS-1103
MICA HEATING BOARD SAUNA ROOM
INSTRUCTION MANUAL
SAUNA ROOM
No advanced advice will be submit before we change our design and size.
The pictures may be a little different from the real products.
Our company keep the final explanation right.

1500X1050X1900mm
1200X1050X1900mm
1
1. Users should read through this manual before assembly and
use.
2. The product must install a reliable earth line and electricity
leak protection.
3. Users should install power supply according to actual
condition.
4. Patients with hypertension or drunk are not permitted to use
this products.
5. Adult guidance is necessary for children or under age to use
sauna.
6. Corrosive liquid are not allowed to bring into the room.
7. Sauna room must not over working for long time. The heat pipe
may damage of long time heating.
8. Our company would not take responsibility if the product is
damaged but caused by violating the normal operating
procedures.
9. When the product is discarded, please deal with it according to
local law.
ATTENTION
TECHNICAL PARAMETERS
1. rated voltage: AC220V±10％ 50Hz/60Hz
2.Power of Sauna heater: 3000w
3. Size:1800X1050X1900mm
10
7.The position of this seat back board can be
adjusted by user.
8.Finish the installation.

1500
1050
1050
1900
The assemble will takes around 2-3 hours
and need 4 people to install the sauna room.
2
front view
plamform
9
4x35
6.Seat installation. Lock the seat frame & seat
back fence by screws.Put it in the seat place .
The whole seat frame should be on the same
horizontal line. Install 2 speakers at the back
side of seat back fence (as drawing). After that,
lock the whole part on the back board. (in
package top board &seat board & its support )
4x35
speakers

After U disassemble the 4pcs package,U will
see many pieces & U need to divide them avoid
making mistake.
3
5.Put the foot plates on the bottom frame in
parallel way. Pls make sure all the angles are
consistent and locking tightly. (in package top
board &seat board & its
8

4
1 Firstly , U need to fix the left back board ,
right back board & back board (in package
side board ,fore& back board package )
near where U want to located the sauna
room .Due to its heavy weight , it is difficult
to move it again after the installation . After
the 3pcs back board standing up , pls. lock
them by screws .
Screws
4x40
4.Put the top cover on the sauna room.(in
package bottom frame & top board ) There are
corresponding holes for the top leds &
explosion-proof light wires.Pull them out from
the holes. After that, check whether all the
angles& position of the top board are correct ,
and lock the corresponding part in the top board.
(in package top board &seat board & its support )
7

3 Screws
4x45
2.It is better to put sauna room near the wall .
Before U move the unfinished sauna room to
the wall ,pls install the electric box on the
board firstly(SAUNA STOVE PACKAGE ) .
U will find a hole on the board and the electric
box wire will go through it & connect to the
power socket. Pls connect the electric box to
the power,then move the part sauna room to
the right place.
5
6
Screws
4x40
3.After fixed 3pcs back boards, fix the front
glass door in the sauna room. Once all the
angles & position of the glass door are right,
lock the screws on the glass door & left ,
right back boards. (in package fore& back
board )