Sunrich Tech S-290 User manual

USB 3.0 2.5’’ SATA Hard Drive
Enclosure
User Manual
Ver. 1.00
All brand names and trademarks are properties of their
respective owners.

MN6000000032 Page2
Features & Specifications
Supports USB 3.0 SuperSpeed and USB 2.0
Maximum transfer rate of 5 Gbps with USB 3.0 and 480Mbps
with USB 2.0; actual speed depends on the hard drive
performance
Supports SATA 2.5’’ hard drives
Supports Plug and Play
No software or drivers required
LED to indicate drive power and activity
System Requirements
Windows® XP/Vista/7 (32/64 bit)
Available USB port
Package Contents
1 x USB 3.0 2.5’’ SATA Hard Drive Enclosure
1 x User Manual
1 x USB 3.0 Cable
Note: Contents may vary depending on country/market.

MN6000000032 Page3
Hardware Installation
1. Chassis Assembly
Disassemble the front panel from the housing by removing one screw
from each side of the housing with a screwdriver, then remove the front
panel
(See Figure A-C)
Figure A Figure B
Figure C

MN6000000032 Page4
2. Hard Drive Installation
Connect the hard drive, install it and fasten the screws
(See Figure D-G)
Figure D
Figure E
Figure F
Figure G

MN6000000032 Page5
Driver Installation
No driver installation is required for Windows operating systems, as
this enclosure is natively supported, so the drivers are already installed.