Sunrich Tech S-360 User manual

USB 3.0 2.5’’ SATA 6G Hard Drive
Enclosure
User Manual
Ver. 1.00
All brand names and trademarks are properties of their
respective owners.

MN6000000034 Page 2
Features
Supports SuperSpeed USB 3.0 data rate up to 5Gb/s
Plug and Play, no driver installation
Compliant to Universal Serial Bus 3.0 Specification, Revision
1.0
Compliant to Universal Serial Bus Specification, Revision 2.0
Compliant with Serial ATA Specification, Revision 3.0
Bus bandwidth of Serial ATA up to 6Gbps
Support any 2.5’’ S ATA hard drive or SSD with thickness up to
12.7mm
LED to indicate drive power and activity
System Requirements
Windows® XP/Vista/7 (32/64 bit)
Available USB port
Package Contents
1 x USB 3.0 2.5’’ S ATA 6G Hard Drive Enclosure
1 x User Manual
1 x USB 3.0 Cable

MN6000000034 Page 3
Hardware Installation
1. Chassis Assembly
Release the latch that holds the top and bottom covers of the enclosure
and slide the enclosure top cover towards to front.
(See Figure A-B)
Figure A Figure B
2. Hard Drive Installation
Place the 2.5’’ SATA hard drive into the enclosure and then slide the
hard drive connector into the SATA connector inside the enclosure,
slide the top cover of the enclosure back onto the frame of the
enclosure.

MN6000000034 Page 4
2.1. Install the hard drive with thickness up to 9.5mm
(See Figure C-F)
Figure C Figure D
Figure E Figure F

MN6000000034 Page 5
2.2. Install the hard drive with thickness up to 12.7mm
(See Figure G-J)
Figure G Figure H
Figure I Figure J

MN6000000034 Page 6
Driver Installation
No driver installation is required for Windows operating systems, as
this enclosure is natively supported, so the drivers are already installed.