TII network technologies MODULAR SC Series User manual

Installation Guide
Models: FDH6 MODULAR SC SERIES
1a. Attach the pole mounting brackets on the indicated
threaded holes.
2a. Hoist the cabinet from the two lifting brackets.
Secure to pole with steel straps or use bolt thru existing
mounting hole on bracket.
Corporate Headquarters:
141 Rodeo Drive
Edgewood, NY 11717
Phone: [phone]
Fax: [phone]
Toll Free: 888.844.4720
[e-mail]
POLE MOUNTING
PAD MOUNTING
1b. Use provided template to drill concrete pad and install
anchors in the right locations. Attach cabinet base to
previously installed anchors. Holes on mounting base can
accommodate 3/8” or 5/16” mounting bolts.
2b. Slide cabinet over mounting base so the bracket on
the back of the cabinet engages the lip of the base, and
then secure with 3 screws from inside the cabinet as
indicated above.
P/N 92252003 • Rev 01 • 2/21/19

3. Open left side door with 3-16 tool. 4. Bring grounding cable thru the hole provided on the bottom of
cabinet, and securely fix to grounding bar.
5. Pull on mounting pin (located on the
far side behind the cassette), and remove
feeder cassette towards the back.
6. Insert feeder cable thru small cable port, tighten external nut, secure
jacket with hose clamp and fix strength member as indicated.

7. Make all required fusion splices inside feeder cassette. 8. Store feeder cable slack on provided
cable management clips. Mount feeder
cassette back and secure in place with push
9. Insert distribution cable thru large
cable port, tighten external nut and
secure jacket with hose clamp.
10. Lay strength member on back panel and
clamp with provided bracket.

12. Remove distribution cassette towards the back by pulling on
the mounting pin (located on the far side behind the cassette).
13. Make all required fusion splices inside
distribution cassettes.
14. Store distribution cable tubes on provided
management clips. Mount distribution cassette back
and secure in place with push pin.
11. Bring all fiber tubes out thru right side door.

15. Open front door with 5/16 tool.
17. Connect splitter leg to desired adapter on distribution field and route cable on provided management clips as needed.
16. Install splitters from right to left slots. Open straps, insert
splitter by pushing it against mounting support until it snaps
in. Secure with straps and route feeding leg thru indicated
clips and connect to appropriate port on feeding cassette.

19. Store unused splitter legs using the provided management clips as indicated above.
18. Insert storage foam block from left side and then
push right side into metal nest on cabinet
1
2