Sunricher SR-2818WIN-ZV User manual

Z-Wave Gateway Controller 09.288WNZV.04159
Wiring diagram
12V DC power input
Method 1:Configure the gateway to your home network, then connect your smart phone with your home network router
Function introduction
Important: Read All Instructions Prior to Installation
Radio protocol Z-Wave Plus
Operation Frequency 868.40MHz/908.40MHz/921.40MHz
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 110x85x24.2mm
• This Z-Wave gateway controller works with Z-Wave lighting devices and secondary controllers.
• Free APP is available for IOS or Android smart phones or tablets.
• Can be controlled by smart phones or home network.
• Waterproof grade: IP20.
Product Data
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
Power Supply 12VDC
Green LED indicator:
Power normal
Red LED indicator:
Z-Wave signal
Blue LED indicator:
WiFi connected
Ethernet
12V DC power
input
Router
Method 2: Connect your smart phone directly with the gateway
12V DC power
input
1-
LED
2-
3-
4-
Z-Wave Controller
Prog.
1-
LED
2-
3-
4-
Z-Wave Controller
Prog.
1-
LED
2-
3-
4-
Z-Wave Controller
Prog.
Note: When the hub
is configured to home router,
use the button to reset WiFi
setting to enable to control
directly through the hub
network again.
WiFi Reset switch: press and
hold down for 10S then release,
the blue WiFi indicator will go
off and go on again, WiFi setting
will be factory reset.
WiFi
(Reset)

Operation
1.Download “Easy Home” APP from “APP Store” or “Google Play” by searching “Easy Home – Smart Home”.
2. If the gateway has been configured to a router, then connect your cell phone to your router network. If the
gateway has not been configured to a router, then connect your cell phone to the gateway network directly.
(Password: 0123456789)
3. Open the Easy Home application and operate according the application manual.