SupaWarm SFH10 User manual

This manual is to be used with the following SupaWarm heater:
SFH10
IMPORTANT:
Read these instructions before use. Please retain for future reference.
2400 Watt
Deluxe Fan Heater
This product is only suitable for well
insulated spaces or occasional use.
INSTRU
C
TION MANUAL

Air Outlet Grille
Thermostat Dial
On/Off Indicator Light
Heat Setting Dial
Oscillating On/Off Switch

AC 220-240V ~ 50Hz, 2200-2400W.
Class of insulation: ll
Ensure that the voltage indicated on the identification plate
corresponds with the mains voltage.
RATING
Please read these instructions fully before use.
THE HEATER MUST BE POSITIONED UPRIGHT.
IMPORTANT INFORMATION
FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH
EC DIRECTIVE 2002
/
96
/
EC.
At the end of its working life, the
product must not be disposed of as
urban waste. It must be taken to a
special local authority differentiated
waste collection centre or to a
dealer providing this service.
Disposing of a household appliance
separately avoids possible
negative consequences for the
environment and health, avoiding
inappropriate disposal enables the
constituent materials to be
recovered to obtain significant
savings in energy and resources. As
a reminder of the need to dispose of
household appliances separately,
the product is marked with a
crossed-out wheeled dustbin.

PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE
USING THE PRODUCT.
When using an electrical appliance, basic safety precautions
should always be observed, as explained in this manual.
WARNING: To reduce the risk of fire, electrical shock,
or injury to person or property:
Check that the mains voltage corresponds with the rating
of the appliance.
touch hot surfaces – Use handles or knobs.
To protect against electric shock, do not immerse cords,
plugs or appliances in water or any other liquid.
leave any appliance unattended while it is operating.
Close supervision is necessary when any appliance is used
by or near children or infirm persons.
Unplug from outlet when not in use or before cleaning.
Allow to cool before putting on or taking off any parts.
operate the appliance with a damaged cord or plug,
or after the appliance has been damaged in any manner.
If the supply cord or appliance is damaged, it must be
replaced by the manufacturer or it
,
s service agent or
a similarly qualified person, in order to avoid a hazard.
In order to avoid a hazard due to inadvertent
resetting of the thermal cutout, this appliance must not be
supplied through an external switching device, such as a timer,
or connected to a circuit that is regularly switched on and
off by the utility.
The use of accessory attachments is not recommended
by the appliance manufacturer, this may cause injuries.
use outdoors.

let the cord hang over the edge of a table or counter
or let it come into contact with any hot surfaces.
To disconnect, remove the plug from the outlet. Do not pull
plug out by the cord.
No liability can be accepted for any damage caused by
noncompliance with these instructions or any other improper
use or mishandling.
use the appliance near a bath, shower or a swimming pool.
place flammable objects or clothing on top of the heater.
Allow a 50cm safe area around the heater on the top and
sides and a 120cm safe area at the front.
use a heater in a room with explosive gas such as
petrol, or while using any kind of flammable glues, sprays
or solvents.
Prevent overheating of the appliance by keeping the air
inlets and outlets clean and free of anything that may cause
blockage. Check all inlets and outlets from time to time for
accumulated dust.
lf overheating should occur, the built-in overheating safety
device will shut the appliance off.
insert any foreign objects into the grill.
Keep the rear grill clear of any draped fabric or curtains.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without
supervision.

Children of less than 3 years should be kept away unless
continuously supervised.
Children aged from 3 years and less than 8 years shall only
switch on/off the appliance, provided that it has been placed
or installed in its intended operating position and they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children aged from 3 years and less than 8 years shall not
plug in, regulate and clean the appliance or perform user
maintenance.
Some parts of this product can become very hot
and cause burns. Particular attention has to be given where
children and vulnerable people are present.
In order to avoid overheating,
Do not use this heater with a programmer, timer, separate
remote-control system or any other device that switches
the heater on automatically, since a fire risk exists
if the heater is covered or positioned incorrectly.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Always use the heater on a flat level stable surface.
The heater must not be located immediately below a socket-outlet.

OFF
Fan Only, No Heat
Low Heat Output
Fu
||
Heat Output
There may be a small amount of smoke emitted as the element
first heats and burns any residue left from manufacture, this
will stop fairly quickly, but it is recommended that a window is
briefly opened to vent smoke released when first used.
THERMOSTAT:
Turn clockwise to increase the heat output.
To use the fan only function:
Remove the heater from all packaging and place it in
desired location.
Ensure that there is a safe area between the heater and
furniture, curtains, etc. 50cm safe area from top and sides
and 120cm safe area in front.
Unwind the power cord and plug it into the power outlet.
Plug the heater into a suitable power outlet, observing all the
instruction regarding positioning, and switch on.
Turn the control dial to “FAN”. The fan will blow out air
at room temperature.
If the fan does not operate, the ambient room temperature
is cooler than the built-in thermostat “OFF” level. Turn
the thermostat dial gradually clockwise and the fan will
start blowing.

As soon as the fan starts, the light in the front of the
machine will illuminate.
To distribute heat evenly around a room, press
oscillating switch.
To use the machine for heating:
Turn the control dial to “l” for low heat and “II” for full heat.
Set the level of heat by turning the thermostat dial gradually
clockwise for the lowest heat and fully clockwise for
maximum.
The thermostat will turn the machine off when the selected
room heating is achieved, and when the temperature drops
it will turn on again automatically.
For maximum heat output use “II” with the thermostat
turned fully clockwise.
The appliance is fitted with a tip-over switch. When you use
the appliance in an upright position on a flat and stable surface,
the tip-over switch will be on. In the event the heater is knocked
over, the heater will stop functioning automatically.

The thermostat will turn the machine off it overheats.
Overheating can be caused by obstruction to the air intakes
on the back of the machine or the grill on the front. If this
occurs please disconnect the machine and allow it to cool
for 30 minutes. Remove any obstruction and turn the
machine back on.
If the heater ceases to function, the most likely cause is a
blown fuse. Simply replace the 13amp fuse in the plug and
reconnect. If the heater still ceases to function, please unplug
it, do not use it and contact the repair centre.
The heater has a built-in safety device, which will switch the
heater OFF in case of accidental overheating.
To reset the heater, follow the next steps:
Turn the control setting to the ‘O
,
position.
Unplug the heater and wait 5 -10 minutes for the unit to cool down.
After the unit has cooled, plug it in and operate normally.
Turn settings switch into desired position (fan, low or high).
Turn the thermostat switch to the desired temperature position.
When you feel the room temperature is comfortable, turn
the thermostat switch anti-clockwise slowly to the minimal
direction until the appliance switches off.
The thermostat switch will keep the room temperature
at the desired temperature automatically.
You can also turn the thermostat switch anti-clockwise
to the minimum position or turn the thermostat switch
clockwise to the maximum position to make the temperature
lower or higher.

There are no parts inside the machine that require your
attention or servicing. Do not try to open the outer case.
By doing so you could damage the motor and heating element
and invalidate the warranty. If you have a problem with the
heater, or if the power cord gets damaged in any way you
MUST take the unit to a suitably qualified engineer or electrical
repair centre.
Before cleaning the machine, please make sure it is
disconnected from the power supply and has cooled
down completely.
Do not clean the machine in water and do not let it get
wet under any circumstances.
The outer casing can be cleaned using a slightly damp
lint-free cloth (a small amount of detergent can be used
if required).
To remove any dust from inside the front grille,or the rear
air intakes, you can use a regular vacuum cleaner.
Always make sure the machine is completely dry before using.
If you are not going to use the heater for a while, it is best
to make sure that it is clean and dry and then store it inside
a plastic bag in a cool dry place.
With sensible care and attention, this heater will give you
many years of good service and economical heating.

We, the importer:
Munro Importers Ltd
























MU IMD
Delaraon oonormit
In aordane with oernment uidane

This marking indicates that this product should not
be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment
or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable
reuse of material resources. To return your used
device, please use the return and collection systems
or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling
For a complete range of fires, radiators
and heaters please call or visit Supa Brands
for further information:
CORRECT DISPOSAL OF THIS PRODUCT