SupaWarm SFH15 User manual
This manual is to be used with the following SupaWarm heater:
SFH15
IMPORTANT:
Read these instructions before use. Please retain for future reference.
2000 Watt
Fan Heater
This product is only suitable for well
insulated spaces or occasional use.
INSTRU
C
TION MANUAL
Air Outlet
Heat Setting Dial
Indicator Light
Thermostat Dial
Air Inlet
AC 220-240V
~
50Hz, 1800-2000W (1000w + 1000w)
Class of insulation:
|
|
Ensure that the voltage indicated on the identification plate
corresponds with the mains voltage.
RATING
Please read these instructions fully before use.
THE HEATER MUST BE POSITIONED UPRIGHT.
IMPORTANT INFORMATION
FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH
EC DIRECTIVE 2002
/
96
/
EC.
At the end of its working life,
the product must not be disposed
of as urban waste. It must be
taken to a special local authority
differentiated waste collection centre
or to a dealer providing this service.
Disposing of a household appliance
separately avoids possible negative
consequences for the environment
and health, avoiding inappropriate
disposal enables the constituent
materials to be recovered to obtain
significant savings in energy and
resources. As a reminder of the need
to dispose of household appliances
separately, the product is marked
with a crossed-out wheeled dustbin.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE
USING THE PRODUCT.
When using an electrical appliance, basic safety precautions
should always be observed, as explained in this manual.
WARNING: To reduce the risk of fire, electrical shock,
or injury to person or property:
DO NOT
DO NOT
Remove the packing and make sure that the appliance is
intact. The appliance must be intact without visible damages
which could be caused by transport. In case of doubt, do not
use it and contact our after-sales service.
leave packaging materials like plastic bags, foam
polystyrene, buttons and staples within reach of children.
Before connecting the appliance, check if the electrical
voltage and frequency of the circuit correspond to those
indicated on the appliance.
In case there is incompatibility between the plug and
the outlet, get the outlet replaced by a skilled electrician.
In general, it is not suggested to use adapters, multiple
outlets and/or extension cords. In cases where they must
be used, only simple or multiple adapters and extension
cords that comply with the current safety rules must be
used. Pay attention to the capacity limit and ensure it is
not exceeded.
Use the appliance only for the mentioned purpose, namely
for heating and for domestic use.
use it for any other application as it could be
dangerous.
The manufacturer is not responsible for any eventual
damages caused by improper or faulty use.
The use of every electrical appliance calls for the awareness
of some basic rules, such as:
NEVER
NEVER
DO NOT
NEVER
NEVER
NEVER
DO NOT
touch the appliance with wet or damp hands or feet.
use the appliance with bare feet.
use extension cords in rooms with a bath or shower
unless you adopt particular prudence.
unplug the appliance by pulling the power cord or the
appliance and expose the appliance to atmospheric
conditions (rain, sun, etc.)
let the appliance be used by children or unable
people without supervision.
Before cleaning the appliance or carrying out any maintenance,
switch off the whole system or disconnect the appliance.
If the appliance malfunctions or is out of order, switch it off
without tampering with it. If any repair is required please
contact the after-sale centres approved by the manufacturer
and ask for original spare parts. Otherwise safety of the
appliance can be compromised.
Check that the electrical capacity of the plant and the current
outlets are adequate to the max power of the appliance
indicated on the rating label.
To avoid overheating risks, you are recommended to completely
unwind the extension cord.
The appliance must not be unnecessarily plugged in. Switch it
off and unplug it when not in use.
obstruct the ventilation or heating louvre.
Keep a minimum distance of 50cm from walls and objects
and avoid direct air flow towards them. On wall corners make
sure there is a minimum distance of 15cm. Fabric, clothing
or other flammable materials may ignite if placed against or
in close proximity to the heater.
If the supply cord is damaged or worn it must be replaced
by a suitably qualified person in order to avoid a hazard.
CAUTION!
In order to avoid a hazard due to inadvertent
resetting of the thermal cutout, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched
on and off by the utility.
When the appliance is not in use, switch it off and unplug it.
Check that the electrical capacity of the plant and the current
outlets are adequate to the max power of the appliance
indicated on the rating label.
Ensure the cord is not in front of the warm air outlet grill.
DO NOT
DO NOT
NEVER
DO NOT
WARNING!
use this heater in the immediate surroundings of
a bath, shower or a swimming pool.
use the heater so either the air inlet or air outlet
is blocked or inhibited. The heater must be placed and used
on its feet.
Keep the outlet grille clean.
install and use the appliance immediately below
a fixed outlet.
use the appliance near liquids or inflammable matters.
At the end of its life, the appliance must not be disposed
of as common waste. Take to your local refuse centre and
dispose of correctly.
In order to avoid overheating, do not cover the heater.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
CAUTION!
Children should be supervised to ensure that they do not play
with the appliance.
The heater must not be located immediately below a socket-outlet.
Always use the heater on a flat level stable surface.
Children of less than 3 years should be kept away unless
continuously supervised.
Children aged from 3 years and less than 8 years shall only
switch on/off the appliance provided that it has been placed
or installed in its intended operating position and they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children aged from 3 years and less than 8 years shall not
plug in, regulate and clean the appliance or perform user
maintenance.
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved.
Some parts of this product can become very hot
and cause burns. Particular attention has to be given where
children and vulnerable people are present.
Before Switching On
Operation
Ensure that all the packing items are removed (read any
warning labels carefully) and that all warnings and instructions
in this instruction manual have been read carefully.
When you are certain that you have positioned the heater
correctly (taking note of all the advice in this manual regarding
positioning and switching on), plug into a suitable power outlet
and switch on at the wall socket. Check that the outlet has at
least a 10 AMPERE current carrying capacity.
There may be a small amount of smoke emitted as the element
first heats and burns any residue left from manufacture, this
will stop fairly quickly, but it is recommended that a window is
briefly opened to vent smoke released when first used.
The fan heater incorporates a rotating control knob. You can
select the different speed options by turning the knob clockwise:
OFF
Cool Air
Warm Air (1000W)
Hot Air (2000W)
Use of the Thermostat
To Use the Fan Only Function
To Use the Machine for Heating:
Turn clockwise to increase the heat output
Turn the control dial to “FAN”. The fan will blow out air
at room temperature.
If the fan does not operate, the ambient room temperature
is cooler than the built-in thermostat “OFF” level.
Turn the thermostat dial gradually clockwise and the
fan will start blowing.
As soon as the fan starts, the light in the front of the
machine will illuminate.
Turn clockwise to increase the heat output
Turn the control dial to “l” for low heat and “II” for full heat.
Set the level of heat by turning the thermostat dial gradually
clockwise for the lowest heat and fully clockwise for maximum.
The thermostat will turn the machine off when the selected
room heating is achieved. When the temperature drops,
it will turn on again automatically.
For maximum heat output use “II” with the thermostat
turned fully clockwise.
The thermostat will turn the machine off if it overheats.
Overheating can be caused by obstruction to the air intakes
on the back of the machine or the grille on the front. If this
occurs please disconnect the machine and allow it to cool
for 30 minutes. Remove any obstruction and turn the machine
back on.
If the heater ceases to function, the most likely cause is a blown
fuse. Simply replace the 13amp fuse in the plug and reconnect.
If the heater still ceases to function, please unplug it, do not use it
and contact the repair centre.
This appliance is provided with two safety devices, one
is self-resetting thermal safety device which cuts the
power to the appliance in case of overheating.
This safety device will reset after it has cooled, to enable
the self-resetting switch off the appliance and unplug it
until it has cooled (about 10 minutes). Once cooled plug
it in and switch on.
There are no parts inside the machine that require your
attention or servicing. Do not try to open the outer case.
By doing so you could damage the motor and heating
element and invalidate the warranty. If you have a problem
with the heater, or if the power cord gets damaged in any
way you MUST take the unit to a suitably qualified engineer
or electrical repair centre.
Before cleaning the machine, please make sure it is
disconnected from the power supply and has cooled
down completely.
Do not clean the machine in water and do not let it get
wet under any circumstances.
The outer casing can be cleaned using a slightly damp
lint-free cloth (a small amount of detergent can be used
if required).
To remove any dust from inside the front grille, or the rear
air intakes, you can use a regular vacuum cleaner.
Always make sure the machine is completely dry before using.
If you are not going to use the heater for a while, it is best to
make sure that it is clean and dry and then store it inside a
plastic bag in a cool dry place.
With sensible care and attention, this heater will give you
many years of good service and economical heating.
C
ORRECTDISPOSAL OF THIS PRODUCT
We, the importer:
Munro Importers Ltd
MU IMD
Delaraon oonormit
In aordane with oernment uidane
Table of contents
Other SupaWarm Heater manuals
