Superfront TOP METOD User manual

Mounting instructions TOP METOD For Two Sides 1/2
Content 3M wet wipe MountPads 10x10mm
(The number varies depending on the size of the top)
Mounting
2. Clean the surfaces.
Use the aached 3M wet wipe to clean the surfaces on
the cabinet and the Superfront top.
Finished result
3M
VHB™
GB Surface Cleaner Sachet
Foruse with 3M™ VHB™ Tapes
FR Pochee de Neoyage
A utiliser avec les rubans 3M™ VHB™
DE Reinigungstuch
Für den Einsatz mit 3M™ VHB™
MOUNTED SUPERFRONT SIDE
CABINET TOP
FLAT HARD SURFACE
ABOUT 1 CM
FROM THE FRONT
EDGE
ABOUT 1 CM
FROM THE BACK
EDGE
NO MOUNTPADS
ON THE SIDE EDGES
The result varies depending on the size of the frame.
3M
VHB™
GB Surface Cleaner Sachet
Foruse with 3M™ VHB™ Tapes
FR Pochee de Neoyage
A utiliser avec les rubans 3M™ VHB™
DE Reinigungstuch
Für den Einsatz mit 3M™ VHB™
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
Safety!
FRONT VIEW BACK VIEW
1. Mount the wall brackets on the cabinet.
Mount the wall brackets supplied by Ikea before mount-
ing the Superfront sides. This is important so that the
top ends up in the right place on the cabinet.
SPACERSPACER FOR BRACKET
3. Aach the MountPads on the frame.
Place the frame on a hard, flat surface with the back-
side down. Aach one MountPad in each corner of the
cabinet top, inside the edges of the cabinet sides, and
spread the rest as shown at the boom of this page.
Place them about 1 cm from the front and rear edge.
NOTE! Do not remove the cover paper from the Mount-
Pads yet!
BRACKET
Continued on back page
Superfront /+46868441814 / [e-mail] / www.superfront.com

Mounting instructions TOP METOD For Two Sides 2/2
4. Tilt the top in place.
Do this step first without removing the cover paper on
the MountPads so that you get the hang of it before you
do it for real.
Place the top on the floor next to the cabinet top, as
shown below.
Slowly tilt the top upward until it touches the Mount-
Pads. Make sure that it ends up in the right position.
MOUNTED SUPERFRONT SIDE
SUPERFRONT TOP
PRESS HARD OVER EACH MOUNTPAD FOR AT LEAST 30
SECONDS. This is important because the adhesive in
our MountPads cure under pressure.
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
Safety!
SHORTER THAN
50 CM.
BETWEEN 51 CM
AND 80 CM.
BETWEEN 81 CM
AND 140 CM.
LONGER THAN
140 CM.
Distribution of MountPads.
Here's how the MountPads should be distributed on the
top of the cabinet frame.
Superfront /+46868441814 / [e-mail] / www.superfront.com