Superfront BRUTA TALL 1/2 User manual

2. Cut the sides to the correct height.
Measure from the floor to the top of the mounted
frames – both at the back and front. Then cut the
sides according to the measurements.
1. Mount the frames, legs and plinth.
Mount your Ikea frames on the wall with the Ikea
suspension rail. Aach the Metod legs from Ikea and
then add the plinth from Superfront.
See separate mounting instructions.
3. Clean the surfaces.
Use the aached 3M wet wipe to clean the
surfaces of the cabinet and the Superfront sides.
4. Aach the MountPads to the frames.
Place the MountPads on the sides of the frames
as shown.
NOTE! Do not remove the cover paper from the
MountPads yet!
Superfront /+46868441814 / [e-mail] / www.superfront.com
Mounting instructions BRUTA TALL 1/2
Content 3M wet wipe
3M
VHB™
GB Surface Cleaner Sachet
Foruse with 3M™ VHB™ Tapes
FR Pochee de Neoyage
A utiliser avec les rubans 3M™ VHB™
DE Reinigungstuch
Für den Einsatz mit 3M™ VHB™
MountPads 40x25mm
(15 per side)
Screws
(the number varies)
Mounting sides
Note! Avoid having open sawed ends near wet areas. A lacquered surface is best but if that is not possible be sure to seal the sawn part using paint or silicone.

Superfront /+46868441814 / [e-mail] / www.superfront.com
Monteringsanvisning BRUTA TALL 2/2
5. Mount the sides in place.
Do this step first without removing the cover paper on
the MountPads so that you get the hang of it before
you do it for real.
Place the side as shown below. NOTE! Make sure that
the back of the side is flush with the wall and in line
with the top edge of the frame.
Slowly tilt the side upwards until it touches the Mount-
Pads. Make sure that it ends up in the right position.
PRESS HARD OVER EACH MOUNTPAD FOR AT LEAST 30
SECONDS. This is important because the adhesive in
our MountPads cure under pressure.
6. Drive the screws.
Press on the outside of the side at the point where
you drive the screw. Spread the screws as evenly as
possible without them being in the way of the hinges,
drawers or shelf supports.e.
7. Mount the doors.
Follow the instructions that come with the hinges from
Ikea. Don't forget to adjust how the doors hang using
the three screws on the hinges. It takes some patience
but is worth it – we promise!
PRESS HERE
PRESS HERE
PRESS HERE
PRESS HERE
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
Safety!