Mounting instructions TOP BESTÅ For No Side 1/2
1. Clean the surfaces.
Use the supplied 3M wet wipe to clean the surfaces on
the cabinet top and the Superfront top.
CABINETS TOP
FLAT SURFACE
ABOUT 1 CM
FROM THE FRONT
EDGE
ABOUT 1 CM
FROM THE BACK
EDGE
2. Aach the MountPads on the frame.
Place the frame on a hard, flat surface with the
backside down. Aach one MountPad in each corner
of the cabinet top and spread the rest as shown in the
picture on the back page. Place them about 1 cm
from the front and rear edge.
Note! Do not remove the cover paper from the
MountPads yet!
Content 3M wet wipe MountPads 40x25mm
(The number varies depending on the size of the top)
Finished result
Mounting
FRONT VIEW BACK VIEW
CABINET SIDE
3. Tilt the top into place.
Do this step first without removing the cover paper on
the MountPads so you get the hang of it before you do it
for real.
Place the top as shown below. Slowly tilt the top upward
until it touches the MountPads. Make sure it ends up in
the correct position before you PRESS HARD over each
MountPad for at least 30 seconds. This is important
because the adhesive in the MountPads hardens under
pressure.
3M
VHB™
GB Surface Cleaner Sachet
Foruse with 3M™ VHB™ Tapes
FR Pochee de Neoyage
A utiliser avec les rubans 3M™ VHB™
DE Reinigungstuch
Für den Einsatz mit 3M™ VHB™
The result varies depending on the size of the frame.
Be sure to always follow the safety instructions that apply to your furniture. Always secure the cabinet to the wall. This also applies to low cabinets where the weight
distribution changes drastically when the fronts open. Especially in the case of solid quality fronts as ours. Use the anchor brackets supplied with the Ikea cabinet.
Safety!
Superfront /+46868441814 / info@superfront.com / www.superfront.com
HOLD YOUR FINGERS ON BOTH SIDES OF THE TOP WHEN TILTING IT
TO MAKE SURE THAT THE TOP IS CENTERED ON THE CABINET TOP.
CABINET SIDE
SUPERFRONT TOP
