Superior SP2400 User manual

VINYL PICNIC TABLE INSTRUCTIONS Models: SP2400, SP2500, SP2400I, SP2500I
cess
Move all components except the table top from the lid of the
box. Place the lid, with the table top, on a at surface and
tear the box at the corners for easier access.
Position the legs of the table
on the cross rails of the top
with the notch of the leg
inboard.
Pass the seat beam through the legs, leaving 10 - 3/4”on both sides as
shown.
Secure the seat beam to
the table leg as shown.
Drive screws into the cross rails on both the outside and inside face
of the leg as shown.

Position the table leg brace in the center to the seat beam. Secure the brace to the beam with screws.
Using the same measure-
ment from the previous
step, position the brace on
the center of the table top.
Make sure that the legs are
square to the top and
screw in place.
(Anything square can be
used to perform the last
step, including the back of
a tablet.).
Finished to this point and ready to be turned over.
Place the benches on the beams and fasten in place with screws, as
shown. Your table is now complete. Enjoy!