
These step by step instructions are provided for you to enable a quick and simple installation of
your camera. Please refer to the diagram over the page for component identification details.
Video BNC Female
DC Power Jack
1b 3
4
3 RCA Video In
120ft AV Cable (Product code SW-P-36M) 60ft AV Cable (Product Code
SW-AVCABLE)
2a 2
1a
2
LL2 AV
AV2
Step 1:
Step 2a: BNC Female BNC Male Adaptor
RCA Male Gender Changer
BNC Male Adaptor
Step 2b:
Step 3: Power Connector power adaptor
Step 4: power adaptor
Step 5: A/V TV TV AV
VCR
VCR A/V Input TV
VCR
instructions VCR TV
A/V inputs.
Note:
At the end of your Mega Flood Camera cable you will find two plugs:
•
•
Plug the ( ) into the ( ) and turn the outer ring
to lock the connectors. Plug the ( ) into the opposite end
of the ( ) and then into the socket on your TV or
VCR (usually located at the back). This is the best method of connecting the camera initially
to test it for correct operation.
If you are mounting the camera permanently it is recommended that you use coaxial
cable with BNC male connectors to ensure the best possible fit and electrical connection.
You can also use the Swann Security Camera Extension cables with BNC adaptors such as
the or the
Check the Swann website for information on other Swann cable and
accessory products or see your local electrical store for more information on what cables
and accessories are available in their range to suit Security Cameras with BNC video
connectors.
Connect the ( ) at the end of the ( ) in to your
Mega Flood Camera’s DC Jack ( ).
Plug the ( ) into the mains power point on your wall and switch on.
If you have an with RCA sockets you will need to switch the to the
channel to view the camera. To connect the camera to your , you will need to turn
the to the selection and turn your onto the channel you would
normally use to view a tape or movie on your . This channel may be activated by a
button on your remote that is marked with this symbol , or or or possibly
or .Please read the for your or for more information on using
their
The Mega Flood Color Camera will automatically change to a black & white image using
the Infra-Red LEDs when available light is too low to support a clear color picture.
11
You should position your cameras to cover the areas most exposed to risk. See
our suggestions below for some ideas:
Where to Place The Security Stickers:
1. On your front window
2. On side windows
3. Near entrance points - doors, gates
4. Next to a dummy camera mounted outside
5. On the front counter
6. On the cash register
7. Next to an obvious camera
1. Doorways
5. Reception
areas
6. Cash
register
7. Mix
dummies
& real
cameras
8. Under eaves
2. Windows 3. Car Parks 4. Verandahs
Tips for locating your camera Connect the Mega Flood Camera to your monitoring device
63