SwannOne Motion Sensor User manual

At a Glance
Thank you for choosing the SwannOne™ Motion Sensor. The SwannOne
Motion Sensor detects movement in a surrounding area, triggering actions and
alerting you on your smartphone when it’s important.
QSGMS150615E
© Swann Communications 2015
Key Fob
Indoor
Camera
Outdoor
Camera
Smart Plug
Motion
Sensor
Door/Window
Sensor
Indoor
Siren
Outdoor Siren
Zen
Thermostat™
Smart
Hub
Discover More SwannOne Smart Home Solutions
EN
Quick Start Guide
Motion
Sensor
At a Glance Compliance Information
3M Command™
Mounting Strip
Motion Sensor
Status LED
Passive Infrared
Motion Detector
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1)This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
Disposal and Recycling Information
Correct Disposal of this product. This marking indicates that this product should not be
disposed with other household wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste disposal, recycle it responsibly
to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product
was purchased. They can take this product for environment safe recycling.
Battery Safety Information
CAUTION: KEEP BATTERIES AWAY FROM SMALL CHILDREN. RISK OF
EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO THE INSTRUCTIONS. www.swannone.com
READ ME
FIRST

Activate Pair Mount Need Help?
1Open the motion sensor by pushing
back the release catch on top and
lifting off the rear panel.
2Remove the protective plastic strip
to engage the battery and activate
the motion sensor.
Place Motion Sensor around your home as
required with the included Command™ Strip.
1Before applying the Command™ Strip, clean
the surface where the Motion Sensor will be
mounted, and make sure it is dry.
2Fit the Motion Sensor with the Command™
Strip, and then press the Motion Sensor firmly
onto surface for 30 seconds.
3Test the Motion Sensor by walking in front of it.
The Status LED biinks whenever movement is
detected. You should also receive a status alert
via the SwannOne web dashboard and app on
your smartphone.
Get more information regarding the setup and use of your product on the web at
swannone.com, or contact our multi-lingual support team anytime via:
[email protected]
USA & Canada 1800 627 2799
UK & Europe 0808 168 9031
Australia 1800 788 210
New Zealand 0800 479 266
AAA
AAA
Plastic
Strip
Connect
Button
Placement Example
Connect
Button
SwannOne Warranty
Your SwannOne products are backed by a full 12 month guarantee from the date of
purchase. In the unlikely event of anything going wrong, you can have confidence that
your purchase is protected. Refer to swannone.com for terms and conditions.
Don't place the sensor near heat or cold producing devices such as heaters, air
conditioners, or lamps as they may cause false triggers.
1Sign in to your SwannOne account at
home.swannone.com.
2From your web account dashboard, go to
My Devices > Motion Sensors and add a device.
3When the Setup page appears, put your Smart
Hub in pairing mode by selecting Learn devices.
4Press the Connect button on the motion sensor.
The status LED blinks once. When pairing is
complete, the status LED blinks twice.
Check the Setup page to confirm the motion
sensor has paired successfully, and then finish
the setup process by following the on-screen
instructions.
If the sensor is not connecting as expected, perform a sensor reset by pressing and
holding the Connect button until the status LED blinks rapidly, and then try pairing the
sensor again.