Activate Pair & Register Mount Need Help?
1Open the Motion Sensor by pushing
back the release catch on top and
lifting off the rear panel.
2Remove the protective plastic strip
to engage the battery and activate
the Motion Sensor.
1Log in to your SwannOne web dashboard at
home.swannone.com.
2Select My Devices, and select add new from the
Motion Sensors menu.
3Select Start Learn.
4Press the Connect button on the Motion Sensor.
The status LED blinks once. Once your Motion
Sensor connects with your hub, the status LED
will blink twice. The on-screen "Motion Sensors
currently registered" counter will increment by 1.
5Select Stop Learn, and complete the rest of the
setup by following the on-screen instructions.
Once complete, put the rear panel back onto the
Motion Sensor until it clicks into place.
Place Motion Sensor around your home as
required with the included Command™ Strip.
1Before applying the Command™ Strip, clean
the surface where the Motion Sensor will be
mounted, and make sure it is dry.
2Fit the Motion Sensor with the Command™
Strip, and then press the Motion Sensor firmly
onto surface for 30 seconds.
3Test the Motion Sensor by walking in front of it.
The Status LED biinks whenever movement is
detected. You should also receive a status alert
via the SwannOne web dashboard and app on
your smartphone.
Get more information regarding the setup and use of your product on the web at
swannone.com, or contact our multi-lingual support team anytime via:
USA & Canada 1800 627 2799
UK & Europe 0808 168 9031
Australia 1800 788 210
New Zealand 0400 479 266
AAA
AAA
Plastic
Strip
Connect
Button
Placement Examples
Connect
Button
SwannOne Warranty
Your SwannOne products are backed by a full 12 month guarantee from the date of
purchase. In the unlikely event of anything going wrong, you can have confidence that
your purchase is protected. Refer to swannone.com for terms and conditions.
If the sensor is not connecting as expected, try performing a hard reset by
pressing and holding the Connect button until the status LED blinks rapidly.
Don't place the sensor near heat or cold producing devices such as heaters, air
conditioners, or lamps as they may cause false triggers.
