SWASH 300 User manual

Swash 300, 900, 1000, 1200, 1400, CL825, SE400, and SE600 Toilet Seat Fit
Information
These instructions are for fitting a Swash bidet toilet seat onto an existing toilet.
How to measure for a Swash toilet seat
Measure the
distance between the bolt holes
.
The space must be between 5-1/4 inches and 8
inches.
Please note: to properly fit SE400, SE600,
IS707, C
L510, and CL950 models, this distance
must be 5-1/2 inches.
Measure the distance from the center of the
bolt holes to the toilet tank to ensure proper
clearance. There must be at least 1½ inches of
clearance.*
Measure the distance from the bolt holes to the front of the toilet bowl to determine if you
have a round or elongated fixture.
If your measurement is 18" – 19½" order an Elongated Swash
If your measurement is 16" – 17¾" order a Round Swash

Please note: some toilets may require an Alternative T-Valve and/or Top Mount Hardware.
* Is the distance from the center of the bolt holes to the toilet tank less than 2 inches?
The Swash may extend slightly over the front edge of your toilet bowl.
Measure the distance from the front of the toilet tank to the front of the toilet bowl.
If this measurement is less than 20½ inches, consider purchasing a Round size to reduce the
amount the seat extends over the front edge, even if your fixture is elongated.
The overall length of the Round Swash is 19.4 inches. A distance less than 19.4 inches from the
tank to the front of the toilet bowl will also cause overhang.
FITTING A SWASH BIDET TOILET SEAT TO A NEW TOILET
If you've decided you'd like to install the Brondell Swash on a new toilet, we recommend you
find a toilet that matches your size, budget, design, performance, and height requirements. Once
you find your toilet, use the toilet manufacturer’s spec sheet and the diagram below to calculate
whether it is compatible. If the value of “D” is greater than 1-1/2 inches, the toilet is compatible
with your Swash.

If you’re looking for inspiration for your new toilet, below is our “Best Of” list.
Please note, Brondell has not used any of these toilets and is not responsible for the performance
of these toilets. Brondell has no affiliation with the manufacturers listed below:
• Best High End: Toto Drake II Two-Piece toilet
• Best High End Concealed Trap Away Toilet (Skirted): Toto Legato One-Piece high-
Efficiency*
• Dual Flush High End: Toto Connelly Close Coupled toilet, 1.28GPF & 0.9GPF
• Dual Flush and Budget-Friendly: Glacier bay 1-piece High Efficiency Dual Flush
Elongated Toilet in White
• Wall-Hung: Toto Maris (Because this toilet uses an In-Wall Tank System, your plumber
will need to provide an accessible ½” water supply connection for the bidet)
*you will need Alternative T-Valve and Top Mount Hardware for this installation
Swash 100 EcoSeat Toilet Fit Information

The Swash Ecoseat S100 is designed to fit Elongated toilets only, however this model will fit
select Round fixtures. Please reference the diagram above for size verification. The Ecoseat S100
will not fit French Curve fixtures.