Проводная оптическая мышь
2
ENG
DESCRIPTION
a: button to turn on/offheadphones (long pressing);
to search an interfacing device (long pressing, as
long as indicator dwill not start to alternate blue
and red lighting);
to Play / Pause (short pressing in Bluetooth mode);
to control calls (short pressing in Bluetooth mode)
b+: volume level increase (short pressing);
next track (long pressing, ~2 sec.)
c–: volume level decrease (short pressing);
previous track (long pressing, ~2 sec.)
dLED indicator
e3.5 mm (3 pin) connector for audio
cable
fMicrophone
gBattery charge indicator
hMicro USB port for charging
a
c
b
e
d
f
h
g
Fig. 1. Headphones design
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the head-
phones application.
Headset charging
•Connect the headphones to a USB port of PC or USB charger using USB to micro
USB cable (included). During battery charging the indicator gis red.
•When the device is charged in full, the indicator gis off.
•There is a short periodic triple beep signal when the battery charge level is low and
the LED indicator dis red.
•The battery in the headphones is used as an integral part of the device, therefore do not
try to extract or replace it, because this can result in the warranty cancellation or the
device damage.
Device turning on/off
•In order to turn on the headphones press and hold the button abefore you hear
a beep signal. When the device is turned on, the LED indicator dwill start blinking
blue. In order to turn offthe device, press once more and hold the button abefore you
hear a beep signal. When the device is turned off, the LED indicator dwill blink red.
Control buttons
When connected to a telephone:
•in order to accept an incoming call press button a. Press button aonce again to
finish the call;
Wireless Stereo Headphones
with Microphone
