Swereco EasyStack 144202 User manual

Instructions for Use
Toilet Seat EasyStack
including splashguard
Safety Instructions:
This product must only be used for its intended purpose.
Toilet lid may not be used as backsupport. See Pic A
The chair must be placed on a flat surface with all four legs
firmly on the ground.
The chair must not be angled in such a position that it only
stands on two legs when the user is sitting on it. Maximum
user weight is calculated with all four legs on the floor.
The chair must not be moved while the user is sitting on it.
The rubber tips must be checked regularly. Damaged or worn
tips could cause deteriorated grip on the floor and should be
replaced. These can be ordered through Swereco.
Before use, make sure the clips for height adjustment are
securely fastened.
If replacing clips, make sure they are the correct size (different
sizes available).
In the event of signs of wear in the height adjustment or that
the product is otherwise worn out, the chair should be taken
out of use and sent in for service.
Maximal user weight 160 kg.
Intended Use: The product is designed to be placed over a toilet bowl to provide additional seat
height, making it easier for users to go to the toilet. May also be used as a commode with a bucket.
Symbols:Explanation of symbols on the product
and Instructions of Use.
Technical specification
Material: Stålrör, PE (sits), TPE (stödfötter)
Manufactured by :
Swereco AB
Vagnvägen 4
SE-364 42 Lenhovda
SWEDEN
Tel: [phone]
www.swereco.com
[e-mail]
Maximum User
Weight 160 kg
Can be washed with alkaline
soap solution , pH 5-9
Wash at a maximum of 85°C for
3 minutes..
Visual control
Product complies with EU
directive 93/42/EEG and
2007/47/EG on medical devices
Article number: 144202, 144204
A
Height difference max 2 steps (5 cm)
snäpp.
2021_031/2
Width 53 cm
Width between armrests: 48 cm
Heigth: 46-62 cm
Seat width: 36 cm
Seat length: 42 cm
Size of hygiene opening:
width 23 cm, lenght 27 cm
Weight: 5,4 kg
Art nr 144204
height 42-57 cm
height armrests 23 cm
weight: 5,2 kg

2021_032/2
Instructions for Use
Instructions for Use:
1. For height adjustment, push the clip off the leg, adjust to the correct height and then push the
clip back in. Make sure the clip is securly fastened before use. If an old clip is replaced with a
new one, check that it is the correct size.
2. Adjust the toilet seat so that all four legs are firmly on the ground by turning the adjustable leg
(white rubber tip). Please note that only the leg with the white rubber tip is adjustable. It is
allowed to switch places of the legs.
3. Apply the splash guard as instructed below.
4. Check the rubber tips before use. Damaged/worn rubber tips must be replaced with new ones.
5. If the shower chair is set in a slight forward-leaning position, the difference in height between
the front and rear legs may not exceed 5 cm, which corresponds to two steps on the height
adjustment.
6. The lid may not be used as a backrest.
Care Instrutions:Clean regularly and whenever necessary (at least once a week) with soap
solution, pH 5-9. When changing the user, the product must be disinfected and then autoclaved
at a maximum 85° for 3 minutes. Alternatively wipe it with 70% isopropanol.
Art nr 144750, Splash guard
Accessories:
Art nr 144785, Lidsupport
Art nr 144210, Soft seat
Art nr 144755, Bucket
Art nr 144760, Bucket w/ handle
Assembly of Art nr 144785, Lid support.
www.swereco.se
[email protected]
www
3144202_ENG
Spare parts:
Art. nr 120700, Rubber tip, grey
Art. nr 120701, Rubber tip, white
Art. nr 14420206, Toilet seat
Art. nr 14420213, Clip 25 mm Art.
nr 14420225-S, 4 legs incl clips
and rubbertips for EasyStack
Make sure the
lid support is
not mounted to
close to the end
of the armrest.
1
6
5
4
3
2
Attach the lid
support to
the armrests
Pull the chord
so that the
band sticks
out 2-3 cm.