SWI-TEC Hydro Charger User manual

SWI-TEC, Neveta Náutica S.L.
Poligono 9, Apt. 51, E-07680 Port Cristo (Mallorca)
Tel. [phone], Fax: [phone]
E-Mail: [email protected], www.swi-tec.com
User Manual
Hydro Charger

2
1
1. Hydro Charger swiveled to upward position
2. Drop of Hydro Charger: by hand forcing back-
wards and smooth guiding with the lifting line
(1)
Start up
Mounting
1. Fixing of transom bracket with counter-plate
and delivered screws. (Smaller openings down-
wards) Attention the Hydro Charger should dive
30 to 70 cm into the water. The position of the
bracket always offset of rudders and propeller.
2. Insert the bracket into the transom bracket
and lock with safety pin.
3. Adjust with the two segments the generator
in vertical position in reference to the water.

3
2
1
2
1
3. Put the Hydro Charger with lifting line (1)
slowly downwards (no falling)
4. Controlled dropping of the Hydro Charger
with the lifting line (1). Mean while pulling the
dropping line (2) of loose.
5. Pulling of the Hydro Charger until to the lock
and to vertical position with the dropping line
(2)

4
2
31
13
7. Release of blockage for hoisting: pull on the
red line (3) and at the same time on the lifting
line (1) to release the blockage.
8. Hoisting: continues pulling of the lifting line
(1) without the red line (3).
Hoisting
6. Short and strong pulling of the dropping line
(2) for blocking of the Hydro Charger in working
position. All 3 lines are now released without
any tension.

5
1
1
2
1
9. Further smooth pulling of the lifting line (1).
10. Dropping line (2) always released for easier
lifting
11. Once arrived at top, positioning by hand in
best position and xing with lash back,
or taking off and store the Hydro Charger in the
boat.