NUCANOE 3005 User manual

Flint/Pursuit Seat Assembly Instructions
Item #3005
1. Seat Fabric Setup
(a) Feed side strap through
loops on back of seat.
(b) Connect buckle and
adjust to desired angle.
(c) Tighten back straps to
snug.
2. Connect Cross Beams to Seat Base
(a) Determine desired seat height:
HIGH POSITION - 9” Height
LOW POSITION - 8” Height
Locknut
Seat Base Tube
2.25” Hex Bolt
Cross Beam
Hex Coved Spacer
HIGH POSITION
LOW POSITION
(b) Install cross beams to seat base using 2.25” hex bolts and hex coved pacers, securing
into washers and locknuts using a 7/16” wrench.
Washer
Hardware Pack 1:
[4] 2.25” Hex Bolts
[4] Hex Coved Spacers
[4] Washers
[4] Locknuts
Locknut
Washer

4. Secure Seat Frame to Seat Base
Hardware Pack 3:
[4] 3.75” Hex Bolts
[4] Washers
[4] Locknuts
HIGH POSITION LOW POSITION
(b) Align the bolts on the Seat Frame with the Seat Base holes. Secure with washers and
locknuts.
5. Ready to install on boat!
Insert 4 Mighty Bolts into track. Place seat over Bolts and secure with Mighty Knobs
3. Connect Cross Beams to Seat Frame
Install cross beams to seat frame using 2” Hex Bolts and Coved
Spacers, securing into washers and locknuts with a 7/16” wrench.
2” Hex Bolt
Hex Coved Spacer
Seat Frame Tube
Cross Beam
Washer
Locknut
Hardware Pack 2:
[4] 2” Hex Bolts
[4] Hex Coved Spacers
[4] Washers
[4] Locknuts
(a) Insert 3.75” Hex Bolts through the center holes on cross beams on seat
frame, as shown above, making sure bolt heads are flush with cross beam.