SeaView PM5-FMD-8 User manual

INSTALLATION
INSTRUCTIONS
For Seaview Camera Mount:
PM5-FMD-8
WWW.SEAVIEWGLOBAL.COM
Refer to website for most up to
date instructions and videos.

PARTS INCLUDED
TOOLS NEEDED
x1 x1
x4 x4
Sudbury Elastomeric
Marine Sealant is
recommended. To
purchase call 800-655-7922
or visit
www.seaviewglobal.com
1

1
2
3
Mark the four base holes for
drilling.
Drill the four holes.
Using a hole saw, drill a hole
for the cable.
2

4
5
6
Apply marine adhesive
sealant to the top of the
mount as shown.
Place the adapter plate
onto the mount making
sure that the four mounting
holes line up.
Apply marine adhesive
sealant to the inner edge of
the adapter plate as shown.
3

7
8
9
Route the cables through the
center channel and mount
the camera to the adapter
plate.
Using the hardware that
came with your camera
secure the camera to the
adpater plate.
Apply marine adhesive
sealant to the base of the
mount.
4

x4
10
11
Route the cables
through the mounting
surface. Place the
mount onto the
mounting surface.
Apply marine adhesive sealant to the four nylon shoulder
washers and insert into the four bolt holes on the base. Use
your own hardware to secure mount into place.
5

This page is intentionally left blank.
6

Tel: [phone]
www.seaviewglobal.com
EUROPEAN OFFICE
Tel: [phone]
www.seaviewprogress.com 1-010819