Swytch Twist User manual

1
Tw i s t
Throttle

2
00
Table of Contents
01 p.3
2
About
Installation
02 p.4

3
About
About
Using a throttle allows you to power your bike without pedalling, by simply twisting
or pushing it to apply power. Without one, the Kit is purely a pedal-assist system.
Throttles must be used off-road or on private land, as in the UK and EU, they aren’t
road-legal. We recommend checking your local laws.
Our throttle is compatible with all Swytch Kits and can be simply fitted by sliding
onto your handlebars. They can be easily added or removed at any time. Throttles are
compatible with most standard handlebars, but unfortunately, they won’t fit on drop
bars.
1.

4
Installation
2. Installation
Fit the twist throttle to the handlebars1.
1.1 The throttle should be on the
right-hand side. Remove your hand
grips and cut them shorter,
allowing a 2mm gap for the throttle.
1.2 Untighten the small screw using
a 2.5mm Allen key. Next, slide on
the throttle. Position it correctly as
shown and tighten the screw,
securing it in place.
!Check your brakes and gear
shifters work as normal.
!Check the throttle does not
touch the hand grips.
!Always fit the spacer inside of
the throttle body.
2mm gap
Hand grips cut shorter
Spacer must be fitted
inside the throttle

5
Connect the twist throttle
to the mount
2.
2.1 Find the mount cable with the same
coloured end as the throttle cable.
The tall end fits into the short end.
Using the arrow on each connector
and line them up. Once aligned, push
the connector pair together until no
colour is visible.

6