Sycreader W90H User manual

User Manual

Introduction
This is a UHF scanner, using wireless identification technology, it supports reading
ISO18000-6c tags.
The scanner adopts high brightness OLED display, which is clearly visible in strong light
environment. The built-in memory can store up to 128 tag information records, and users
can upload the information to the computer through USB cable. It can also be uploaded to
the device in real time via wireless 2.4G or Bluetooth.
This product has stable performance and simple operation, and is widely used in small
animal management, warehousing and logistics, resource management, railway detection,
etc.
①Tag type
②USB connect
③USB port
④Battery status
⑤Tag ID
⑥Scan button

Parameter
PROJECT
PARAMETER
MODEL
W90H
WORKING FREQUENCY
915Mhz
SUPPORT TAG
ISO 18000-6C
READING/ WRITING RANGE
UHF label 0~35cm (related to label performance)
STANDARD
ISO18000-6C
READING TIME
＜100ms
PROMPT
0.91 "high brightness OLED screen, buzzer
POWER SUPPLY
3.7V (lithium battery)
MEMORY
128 pieces of information
COMMUNICATION
USB2.0, Wireless 2.4g, Bluetooth
LANGUAGE
English or customized
WORKING TEMP
-10℃~50℃
STORAGE TEMP
-30℃~70℃
PACKAGE SIZE
18.5cm×12cm×3cm
WEIGHT
120g

Operation
Turn on the device and scanning.
Press scan button to turn on the device and on scanning model
The tag NO. will be displayed on screen if detect a tag, display
“No tag” if no tag is detected.
Device could be charged and uploaded data by USB cable.
When device is connected by USB,” USB” will be displayed at
top left corner, and on charging status for battery status.
The device is connected via wireless 2.4G, the tag data will be
uploaded to the receiving device in real time, and the wireless
connection symbol will be displayed in the upper right corner
of the screen after inserting the receiver, as shown in the
figure:
The device is connected via Bluetooth, and the tag data will be
uploaded to the receiving device in real time. Find the device
named SYC READER on the receiving end. After the connection
is successful, the Bluetooth logo will appear in the upper right
corner of the screen, as shown in the figure:
Press scann button for 3s, data will be uploaded from the
scanner, MAX 128 records.
After uploading successfully, display as below
The data can be upload in real time if scanner is connected by
USB cable when reading a tag.
Scanner will be off after 120s without working.