Sycreader X Series User manual

2D scanning plaorm
Quick Setup Guide
Series X (1000)
1. Factory reset
Note: Please use the "Factory Reset" funcon
with cauon, aer reading this seng code,
the current parameter sengs will be lost
and replaced by the factory default values.
Factory reset
2. Communicaon interface
The 2D barcode scanning plaorm provides
USB keyboard interface, USB-COM virtual
serial communicaon interface to
communicate with the host. Through the
communicaon interface, you can receive
reading data and change the funconal
parameters of the QR code scanning
plaorm.
** USB-KBW
USB-COM
3. Symbol switch
Long press the top buon for 5 seconds, you
can turn on/o QR code reading, choose
whether to recognize the QR code according
to your needs in a specic scenario, prompt
sound two tones to indicate that QR code
reading is on, prompt sound one tone means
that QR code reading is closed, can only read
1D code.
4. Tone sengs
Click the top buon to set dierent
frequencies of tones, a total of four styles of
tones and mute mode, click the buon to
switch between these modes.
5. Reading mode sengs
** Inducon mode
Connuous mode

6. Country/language keyboard layout
selecon
The keyboard key arrangement and symbols
corresponding to dierent naonal languages
are dierent. It can be virtualized into
dierent naonal keyboard formats as
needed.
** US keyboard
France
Italy
Germany
Spain
Russia
7. Modify the terminator
Reading the following seng code, you can
quickly set the terminator to carriage return,
carriage return + line feed or TAB key.
**Carriage Enter
Carriage Enter + Line Feed
TAB
No terminator
8. Case conversion
Read the following setup code to convert
uppercase and lowercase leers in the output
data.
** No conversion
All in uppercase
All in lowercase
Case swapping