SYDELL 930-2 User manual

NOTE: ALSO CAN TIGHTEN SET SCREW ON BEARING AT THIS TIME.
PLACE 5/16 X 1" BOLR THROUGH HOLE ON PIN AND TIGHTEN.
INSERT THE CURVED PIPE THROUGH THE HOLE ON THE LOCK/RELEASE
AND THEN USE 1 /4 X 1 1/4" BOLT TO MAKE SURE PIECE DOES NOT SLIDE OUT.
AND SECURE WITH LINCH PIN. (THIS IS YOUR LIFT HANDLE)
TAKE THE HANDLE ON THE RIGHT SIDE OUT AND PLACE IT IN THE
1 1/4" SQUARE TUBING ON THE BOTTOM RIGHT OF THE TABLE AS SHOWN
LOCATE BOTH HANDLES ON THE TOP OF THE CAGE. TURN THE HANDLE
ON THE LEFT 90 DEGREES AS SHOWN AND TIGHTEN SET BOLT
INSERT PIN THROUGH GATE AND THEN INTO BEARING ON CAGE.
SET COMPLETE CAGE INTO ASSEMBLED FRAME. LIFT UP ON CAGE AND
INSERT 1" SQAURE STABILIZER BAR (A) INTO 1 1/4 SQUARE TUBING ON
BACK OF BOTH END GATES AS SHOWN AND SECURE SET BOLT.
BOTTOM OF BOTH END GATES AS SHOWN AND SECURE SET BOLT
INSERT 1" SQAURE STABILIZER BAR (B) INTO 1 1/4 SQUARE TUBING ON
ASSEMBLY INSTRUCTIONS FOR #930-2
TILT TABLE
STEP #5
NOTE DIAGRAM B
STEP #7
STEP #6
STEP #4
STEP #3
STEP #1
STEP #2
SYDELL INC.
46935 SD Hwy. 50
Burbank, SD 57010
[phone]
www.sydell.com
email: [email protected]

STABILIZER BAR (B)
CURVED SIDE OF CAGE NOT SHOWN
TOP OF CAGE
CURVED PIPE
LOCK/RELEASE
DIAGRAM B
BEARING
HANDLE
MAIN CAGE
3/4" PIPE
1 1/4" SQUARE TUBING
PIN
TILT TABLE
ASSEMBLY INSTRUCTIONS FOR #930-2
LEFT END GATE
3/4" PIPE
1 1/4" SQAURE TUBING
BEARING
PIN HANDLE
STABILIZER BAR (A)