INSTALLATION INSTRUCTIONS
SYMBIOTE.COM SYMBIOTE.COM
sheet 1 of 2p/n 14043006-01 rev A
STORAGE AND DISPLAY
Storage Accessory Mounting Brackets
Product Numbers
• ASMB
Hardware Pack: ASMBHP (p/n 14043007-01)
Pedestal Mount (steps #1-4)
Required Tools
• #2 Phillips Bit
• #4 Phillips Screwdriver
• Cordless Drill/Driver
Orient brackets with the arrow end pointing towards
the front of table. Space brackets 9" apart and allow
clearance under table for the 15" wide pedestal. For
a close t of the pedestal on the le/right side of
the table, position bracket approximately 3 " from
the inside of the table leg. Attach brackets to sur-
face with (6) #10-12x¾" screws using a #2 Phillips
bit and cordless drill.
Remove pedestal drawers per installation instruc-
tions. Align center of rear keyslots in pedestal with
the preinstalled screws in the brackets. Slide the
pedestal back to engage screw. While support-
ing the front of the pedestal, install (2) 5⁄16-18x¾"
Phillips pan head screws through the front key-
slots of the pedestal in the front weldnuts of the
brackets. Tighten all four screws with a #4 Phil-
lips screwdriver.
Insert (2) 5⁄16-18x¾" Phillips pan head screws in the
back weldnuts of the brackets, leaving a ¼" gap
between the underside of screw head and bracket.
1
3
2
#10-12x¾" screw
(96121301)
3 " 5⁄16-18x¾" screw
(93022302-03)
5⁄16-18x¾" screw
(93022302-03)
9"
