Systemline LRN7 User manual

LRN7LRN7
Learning Programmable
Remote Handset

15
2
WARNING
Contains small parts.
Not suitable for use by
infants.

3

4

5

6

7

8

9

10

11

12
Modular Address
Setting
This feature allows you to select
your preference for the Modular
Address. The range for the Modular
Address is between 0 and 31.
You must enter User Setup Mode
to perform this operation.
Press ‘Local’ key to select the
Modular Addressing option.
The Tuner and Video LED’s should
be blinking.
The remaining LED’s represent the
Modular Address.
To determine the Modular Address
add the corresponding values for
each of the LED’s that illuminated
based on the following table:
LED Value if LED
Illuminated
Disc 16
Aux 1 8
Local 4
Satellite 2
Aux 2 1
Table 1:Modular Address cross reference
from LED’s
To change the Modular Address, use
the number keys to enter the 2 digit
address. i.e to select the Modular
Address 5, press then .
Press the ‘OK’ key to confirm
the selection, or press the ‘Menu’
key to cancel.

13
Modular Setup
Mode
This feature allows you to configure
the settings on your Modular
System.
To enter Modular Setup Mode
Press and hold the ‘Standby’
and ‘Local’ keys for
approximately 5 seconds.
A sound will be heard and the
Tuner, Disc and Sat LED’s should
be blinking.
The following table describes the
LED’s which represent the Modular
parameters:
LED (ON)
Modular
Setup Param-
eter
Video 1. Turn on
volume
Video + Aux 1 2. Bass
Video + Aux 1
+ Aux 2 3. Treble
Video + Aux 1
+ Aux 2 +Local
4. Maximum
Volume
Table 2:Modular Setup Parameters
To increase or decrease the setting
for the selected Modular Setup
Parameter press the‘Up’ or
‘Down’ arrow keys respectively.
To accept the current setting and
advance to the next Modular Setup
Parameter press the ‘OK’ key.
To exit Modular setup Mode
either press the ‘OK’ key in
Maximum Volume Mode, or again
hold down the ‘Standby’ and
‘Local’ keys for approximately

14

15