SYSTEMS Remanufactured Herman Miller Aeron User manual

Remanufactured Herman Miller Aeron
© Systems Office Furniture
1
SYSTEMS
Office Furniture
S
PostureFit
SystemsOffice.com/assembly
Visit Our Assembly Page
Have a question or need help
with assembly? Reach out to us.
Monday - Friday
8:00 am - 5:00 pm CST
979.776.2100
SystemsOffice.com
If you are missing parts or
discover defects and/or damage
while assembling this product,
you could be eligible for a
replacement free of charge. We
are always here to help.
© Systems Office Furniture
1
Assembly
Code: 6-1

What’s in the box?
© Systems Office Furniture
2
Allen Key
Step One
Place the base on the oor and line the Seat Back up with all four holes.
Step Two
Hand tighten the screws to set them in place. Starting at the top, use the
provided Allen Wrench to tighten all 4 screws counter-clockwise. Enjoy!
Seat Bolts (4)
Partially Assembled Seat Base
Seat Back 12
34
Allen Key
#2 Screwdriver

© Systems Office Furniture
3
Step Four
Support the bracket with your hand while you hand tighten the screw
back into place with the screwdriver provided.
Step Three
Locate cable and mounting clip under seat pan. Clip the
bracket on the chair, lining up the two holes for the set
screw. Make sure the holes align.
Step Five
Guide the cable through the hole with your ngers then slide down. Press
the bottom of the Y of the PostureFit to meet the cable.
Note: If the cable is too short, loosen it by turning the
PostureFit dial on the side of the chair.
Line Up
Step Six
Enjoy your chair!