Sytech SY-HV27 User manual

SY·HV27
KETTLE
USER
MANUAL

Welcome
Congratulations on the purchase of your new kettle SY-HV27. In order to fully benefit from this product
please read the following instructions carefully. Store this user manual in a safe place for future
references.
Safety instructions
oThis appliance is designed for domestic use only and not for commercial applications
Sytech is not responsible for damage resulting from improper use or from non-
compliance with the user manual.
oThis appliance is designed for boiling water only. Never operate the kettle with any
liquids other than water.
oBefore inserting the mains plug into the socket, ensure that the power voltage and
rating comply with the rated electric parameter shown on the appliance label.
oDo not operate the appliance with wet hands.
oNever allow the base or the bottom of the kettle to make contact with water. Never
immerse the base or the kettle in water. Should any of the above occur, contact
Sytech Service Centre before using it again.
oIn order to comply with safety regulations and to avoid hazards, repairs of electrical
appliances must be carried out by qualified personnel. If repairs are needed, please
contact Sytech Service Centre.
oIf the supply cord is damaged, contact Sytech Service Centre.
oDO NOT operate the appliance if:
The appliance or the power cord are damaged
The appliance has been dropped.
oAlways remove the plug from the wall socket:
After use
In case of any malfunction
Before cleaning
oWhen removing the plug from the wall socket, never pull on the power cord.
oAlways place the appliance away from children.
oChildren must be supervised to ensure that they do not play with the appliance.
oDo not attempt to remove any parts of the housing nor insert any metal objects into
the interior of the appliance.
oTo prevent damage to the power cord, always keep it away from sharp edges or
corners.
oDo not place the power cord over or near hot surfaces.
oDo not expose the appliance to rain or moisture and do not operate the appliance
outdoors or with wet hands.
oOnly use clean cold water, and let the water run for approximately 1-2 minutes before
filling.

oDiscard water after boiling for the first time.
oNever operate the kettle dry. Always ensure the kettle is filled with water before
operating it.
oCAUTION: The appliance operates at very high temperatures; there is a chance of
scalding from the escaping water or steam. Do not touch any part of the kettle except
the handle when the appliance is in use and ensure that the lid is properly closed.
oWhen using the appliance, always pay attention to the water level marking on the
exterior of the kettle. Do not let the water level drop below the minimum level and
never exceed the maximum level.
oIf the kettle is overfilled, boiling water may overflow causing the risk of scalding.
oAlways place the appliance on a firm and uniform surface.
oThis appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instructions concerning use of the appliance by a
person responsible for their safety.
oWARNING: never open the lid when the water is boiling.
oAlways use the kettle with the base provided.
General description
1) Lid
2) Handle
3) On/Off switch
4) Base
5) Function Indicator light
6) Water level indicator

Operation guidelines
Before the first use
oPrior to initial use, clean the kettle by going through several boiling cycles using clean water each time and
filling the kettle to its maximum capacity. The water will reach boiling point after approximately 5 minutes. At
this point the appliance switches off automatically. Whilst the water is boiling, a red light will indicate that the
water is boiling, once this has finished, the red light will turn off to indicate that the boiling process has
finished.
Using the kettle
oPlace the heating base on a firm and uniform surface
oPour the desired amount of water into the kettle and make sure the lid is closed properly. The water level can
be measured by the level mark on the exterior of the appliance. Once the appliance is functioning, do not
touch any part other than the handle.
oPlace the kettle carefully onto the base.
oInsert the plug into the wall socket.
oTurn on the appliance to start the heating process; a red light will turn on inside the unit showing that it is
operating.
oAs soon as the water has boiled, the appliance will switch off automatically and the light will turn off. If a lower
water temperature is desired, the appliance can be switched off manually as well.
oThe water may now be poured safely through the spout into another container.
Safety cut-out feature
oThe kettle is equipped with a safety cut out feature. Should the kettle have no water and the switch is turned
on, the switch will automatically turn off.
oIn such cases, unplug the appliance and reuse it after 30 seconds.
Decalcifying
oIf the appliance switches off before reaching boiling point, it is a sign that decalcifying is needed.
oAny regular de-scaling agent may be used, provided that the relevant instructions are observed.
oTo clean the kettle thoroughly after decalcification, let it go through several boiling cycles using clean water
each time. Rinse the kettle with clean water afterwards and let it dry before re-use.
Cleaning and care
oAlways ensure that the plug is disconnected from the wall socket, and that the unit has fully cooled down
before cleaning the kettle.
oDo not use abrasive cleaning products.
oDo not immerse the base or kettle in any liquids. To clean the body (exterior), use a slight moist lint-free
cloth.
oIt is advisable to remove lime deposits from the kettle at regular intervals.
Specifications
Supply Voltage: 220~ 50Hz,
Power: 1500W.
Capacity: 1.8 Litres
Material: Plastic

Environment
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for environmental safe
recycling.
Declaration of Conformity
Manufacturer Name: Satyatrade S. L.
Address: Pol. Ind. La Raya. C/ Guadalquivir, 2.
Camarma de Esteruelas, 28816 Madrid
Tel: [phone]
Fax: [phone]
NIF: B83254763
Manufacturing country: China
Description: Water kettle
Sytech® SY-HV27 complies with the following directives:
EMC Standard: Directive: 2014/30/EU
LVD Standard: Directive: 2014/35/EU
LFGB Standard: EN13130-1:2004
ROHS standard: 2011/65/EU Restriction of Hazardous Substance
Signed: Ajeet Nebhwani Utamchandani
Sole Administrator