INSTRUCTION FOR USE
1 2 3 4
5 6
9 10
7 8
Remove the cap of the lancing
device.
Insert a lancet into the lancet
holder and push down firmly
until it is fully secured.
Twist the protective disk off the
lancet.
Replace and twist the cap until tight
Hold your finger on the cap of
depth number NOT the body
Select the desired depth of
penetration by turning the
adjustable tip as show in the
picture.
Adjustment:
1 - 3 soft or dedicated skin
4 - 6 normal skin
7 - 9 thick or callused skin
Pull the cocking control back
until it clicks. You will see a
color change inside the release
button when it is ready.
Lancing the finger
Press the lancing device’s tip
firmly against the lower side of
your fingertip. Press the release
button to prick your finger,
then a click indicates that the
puncture is complete.
Remove the device from the
puncture site. After penetration,
remove the first drop of blood with
a clean cotton swab. Gently squeeze
the punctured area to obtain
another drop of blood. Be careful
NOT to smear the blood sample.
Apply the blood to the test strip.
Remove the lancet by pulling
the cap off first. Safely dispose
of the used lancet by placing
the protective disk on a hard
surface, and pushing the
exposed tip into the disk.
Slide the ejector forward to
remove the used lancet.
Dispose of the lancet according
to your local regulations.
B1-7F., No.127, Wugong 2nd Rd., Wugu Dist.,
New Taipei City 24888, Taiwan
Tel : +886-2-6625-8188 Fax : +886-2-6625-0288
TaiDoc Technology Corp.
1
2
LANCING DEVICE
and TWIST LANCET
TD-5011
