Tanco S200V User manual

TRACTOR CONNECTION
1. Hydraulics
Red pipe > Supply (35-40lpm)
Blue pipe > Return (Free flow return!!)
2. Electrics
A. Connect 12V supply to 3pin plug
B. Connect wrapper harness to controller
ENTERING THE WORKING POSITION
1. Remove the wrap arm transport lock.
2. Position the safety arms into the working
position by removing the retaining pin.
3. Adjust the load arm stop pin to allow
clearance between the top of the bale at the
rotating arm.
4. Unfold the wrap arms and install the 2/3
rolls of film.
The quick reference guide is not a substitute for the Operators Manual!
Please refer to Operators Manual for more detailed information
B
A
3
4
1
2
S200V / S300V QUICK REFERENCE GUIDE

OPERATION
1. Drive into the bale until the End Tip
roller contacts the bale.
2. The bale will then begin loading
automatically.
3. Once loading is complete, the
wrapping process will begin
automatically.
4. Once wrapping is complete, press the
“Rollers out” button to offload the
bale.
1. Drive into the bale.
2. Press the “Rollers in” button (a) to load
the bale.
3. Once the bale is loaded, press “Auto
Start” (b). Wrapping will then begin.
4. Press the “Rollers out” button (c) to
offload the bale.
a
b
c
Using the End Tip
Note: End Tip must be set to ‘ON’ in the
Operator Settings.
1. Press the “Rollers out” button (a). The
End Tip will first extend, before the
rollers move out to unload the bale. a
Auto mode (A) Auto load + Auto wrap
1
Auto mode (A)
Auto mode can be used with some of the Auto features switched off. These
are: Auto load, Auto wrap, Auto unload. This can be done in the Operator
Menu. This allows the operator to decide when they would like each step to
begin. The below instructions explain how to carry out each Auto step
individually.
4

EXPERT PLUS CONTROLLER OPERATION
OPTIONAL RF REMOTE OPERATION
The RF (Radio Frequency) remote is required if you wish to operate the
S200V / S300V statically.
Auto Start wrap
Close Cut & Start
Offload the bale
Emergency Stop
Rotate wrap arms
in reverse
Rotate wrap
arms forward
Load bale / add
extra wrap
Open Cut & Start
RF Receiver
The red button on the
rear of the remote must
be pressed while
pressing any other
button (except “STOP”).
- Current No. of wraps
- Target No. of wraps
- Wrapping speed (RPM)
- Bale total
- Grand total No. of bales
- Mode: Manual / Auto
Arm fold (Seq. Reset in Auto)
Arm unfold (Clear warning)
Fast wrap / Resume wrapping
Rolls rotate (Pause bale
rotation in Auto)
Rollers in
Auto start wrap cycle
Pause wrapping in Auto
Close cutter
Open cutter (add extra wrap in Auto)
Select Auto or Manual
Slow wrap
Menu
Reverse wrap arm
Rollers out
Power on/off / Emergency Stop

ENTERING THE TRANSPORT POSITION
1. Fully close the loading rollers.
2. Ensure the wrap arms are in the
folded position.
3. Rotate the folded wrap arms until
they are behind the Cut & Start.
4. Insert the wrap arm transport lock.
5. Lock the outer safety arm into the
transport position. 5
4
OPTIONAL HANDHELD REMOTE
The operator can activate the main wrapper functions through the handheld
remote. This means that the operator can hold the remote in their hand while
operating the tractor.
Rollers out
Manual
Reverse rotate
Auto mode
Auto start wrap
Rollers in
Manual
Slow rotate
forward
Auto mode
Auto start wrap