Tangent Medix T22B Guide

________________________________________________________________
Medix T22B & T24B
Battery Contact PCB Replacement
Instructions
May 2017

Medix T2x Series Battery Contact PCB Replacement Instructions
2
How to replace the Battery Contact PCB for Medix T22B & T24B
Medical-Cart Computer: Some of the pictures in this
instructions may not be exactly the same as the product you
have but the procedures should be the same.
NOTE: PREPARE A CLEAN WORKING SURFACE TO PROTECT SYSTEM’S
DISPLAY & CASE FROM SCRATCHES & DAMAGE.
If a Stand is not installed on the unit, please skip items 1 & 2, & go directly to
item 3.
1. Slide the Stand Cap up. Remove the Stand Cap.
2. Remove 4- M4 screws. Remove system from the stand.

Medix T2xB Series Battery Contact PCB Replacement Instructions
3
3. Remove the Front Bezel. The Front Bezel is attached to the system by snap
clips. Put fingers on each side of the Front Bezel and gently pull it up.
Turn the system over with the screen facing down.
4. Remove a M3 x 10 mm screw. Remove the SODIMM cover for Medix T22B.
(You do not need to remove the SODIMM cover for Medix T24B)

Medix T2xB Series Battery Contact PCB Replacement Instructions
4
5. Remove 2- M3 x 10 mm screws. Remove the HDD cover.
(If there is no HDD installed, you do not need to remove the HDD cover.)
If there is the HDD in the compartment, disengage the cable and remove the
HDD.

Medix T2xB Series Battery Contact PCB Replacement Instructions
5
6. Remove the base cover.
a) Remove 11- M3 x 10 mm screws for Medix T22B.
Remove 15- M3 x 10 mm screws for Medix T24B.

Medix T2xB Series Battery Contact PCB Replacement Instructions
6
b) Remove 3- M3 x 10 mm screws for Medix T22B.
Remove 3- M3 x 10 mm screws and 2- M3 x 6 mm screws for Medix T24B.
c) Remove base cover from the system frame.

Medix T2xB Series Battery Contact PCB Replacement Instructions
7
7. For replacing the Battery Contact PCB.
a) Remove 6–M3 x 6 mm screws (2 screws for each PCB). Disconnect the
cables by gently dislodging the connectors from the connector housings.

Medix T2xB SeriesBattery Contact PCB Replacement Instructions
8
b) Place new Battery Contact PCBs into the bracket. Apply 6 screws and
engage the cables.
For re-assembly, follow the previous instructions in reverse.