Tauris DONATA1800 Installation guide

www.rvm.com.au
Assembly Instruction Manual
MODEL NO.: DONATA1800
- Please follow these assembly instructions as it will save you time, make
assembly easier and prevent possible damage to your new unit.
- Correct assembly is your responsibility.
- We strongly recommend that the unit is assembled on a soft surface such
as carpet or blanket.
as power tools can strip threads if over tightened.
- When moving this furniture item, always carry the unit. Dragging or
sliding the unit could damage the unit and the floor surface.
1500
128 -192
530
535
160
360
390
1800
330
670
130
200
535

ANTI-TIPPING MECHANISM
WALL PLUG
ANTI-TIPPING MECHANISM
SAFETY STRAP
ANTI-TIPPING MECHANISM
LOCKING SCREW
ANTI-TIPPING MECHANISM
PLATE
TOPSMALL SHELF
CABLE MANAGEMENT BASE FRONT LEG FRAME LEG CROSSMEMBER REAR LEG FRAME LEFT DRAWER PANEL
RIGHT DRAWER PANEL DRAWER CROSSMEMBER DRAWER BASE LEFT DRAWER FRONT RIGHT DRAWER FRONT
LARGE SHELF LEFT DOOR RIGHT DOOR
REAR DRAWER PANEL

OVERVIEW

1. HAND TIGHTEN THREADED BAR(29) INTO THE LEG FITTING FIRST
2. SLIDE CROSS RAIL(10) ONTO THREADED BAR(29)
3. TIGHTEN NUTS WITH THE SPANER PROVIDED(30)
arrowhead on cam points
toward to the hole on the
panel edge.

arrowhead on cam points
toward to the hole on the
panel edge.
1A 1B

arrowhead on cam points
toward to the hole on the
panel edge.
MAKE SURE THAT THE CABLE MANAGEMENT
HOLES ARE POSITIONED AS SHOWN

1A 1B

AFTER THIS STEP IS COMPLETE,
ROLL THE CABINET OVER ONTO
ITS FEET.

NOTE: For gyprock walls
ensure you locate the
studs, or use appropriate
to the wall. (also see Step 14)
Use a screw driver to
fasten the screws
(Part 25) into the wall.

Use a screw driver to
fasten the screws
(Part 39) into the
bracket.

Drawer Front Alignment
Drawer front panel
If the drawer front panel is NOT level after being assembled, then...
Loosen the screws on the left and right hand side, then move the drawer slide up or down,
untill the drawer fronts are even/level, then tighten the screws
Loosen the screw
Adjust the slide up or down
Drawer front panel
Drawer Side
Drawer Runner

SURFACE CARE INSTRUCTIONS
A little care and attention will extend the life and good looks of your furniture. Take care when using
materials which might spill, or be sharp or abrasive, on the surface of your furniture.
Normal Cleaning: For normal cleaning use a soft, dry, clean cloth.
Glass Cleaning for Frosted Glass: Do not use glass cleaner or solvent based cleaners on glass that
has a frosting effect on it.
Normal Glass Cleaning: You may use normal glass cleaning products on all other types of glass. Use a
soft non-abrasive cloth to remove light dust and finger prints.
Leather, Vinyl & Speaker Cloth Cleaning: Under no circumstances should any abrasive materials be
used on these surfaces, as it will result in irreparable damage.
Do not use solvents, solvent based cleaners, scouring pads, steel wool or scrubbing brushes to clean
this furniture item.
Only use a slightly damp, soft, clean cloth on this surface if cleaning is needed. Do not scrub.
CAUTION
As with all furniture, this unit should not be exposed to direct sunlight, extreme temperatures or
moisture, as this can result in irreparable damage.
Note: The sooner a spill or mark is cleaned, the easier it will be removed.
Customer Service
FOR ALL MISSING OR FAULTY PARTS: PLEASE RE-CHECK YOUR PACKAGING TO ENSURE THAT PARTS
ARE MISSING THEN CONTACT THE STORE YOU PURCHASED THE ITEM FROM.
THE STORE WILL NEED THE FOLLOWING INFORMATION…..
- COPY OF YOUR PURCHASE SLIP/RECEIPT
- MODEL NUMBER OF THE UNIT PURCHASED
- DESCRIPTION/PART NUMBER OF THE MISSING OR FAULTY PART
- QUANTITY OF THE PARTS NEEDED
If for whatever reason you cannot contact the store, please contact Tauris direct at
http://www.rvm.com.au/contact.
Product of:
RVM Australia
11 Tamara Drive, COCKBURN CENTRAL
Perth, Western Australia 6164
PH: 08 9417 9944

WARRANTY STATEMENT AND POLICY
1. Nothing in this Warranty aects the Consumer’s rights under the Australian Consumer law. The
benets to the Consumer under this Warranty are in addi on to the rights and remedies of the
buyer under any Consumer Guarantees. The Australian Consumer Law requires that we conrm
that:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
You are en tled to a replacement or refund for a major failure and for compensa on for any
other reasonably foreseeable loss or damage. You are also en tled to have the goods repaired or
replaced if the goods fail to be of acceptable quality and the failure does not amount to a major
failure.
2. Subject to Clause 1, the Seller warrants that branded products will be free of
manufacturing defects and will perform to the Seller’s specica ons subject to the following
clauses.
3. The benet of this Warranty extends only to the owner of the property in which the Products
manufactured or supplied by the Seller are installed and used by the owner for the dura on of the
Warranty Period.
4. The Warranty commences on the date of the purchase of the product and con nues for the benet
of the Owner for the Warranty Period. If within the Warranty Period a manufacturing defect is
discovered in the Product, or the Product fails to perform to the Seller’s specica ons as a result of
some defect in material or workmanship in the Product, then the Seller will at its own discre on:
a.) Repair or replace the Product at the cost of the Seller, including but not limited to labour and
travel costs. Goods repaired or replaced under this Warranty will be warranted for the
remaining period of the Warranty.
b.) Refund the purchase price paid by the consumer.
5. The Warranty does not apply to Product that :
a.) Has failed due to excessive wear and tear beyond what is considered to be reasonable.
b.) Has been misused or neglected.
c.) Was been damaged accidently or by acts of God including re and ooding.
d.) Has been used or operated contrary to opera ng or maintenance instruc ons.
e.) Has been damaged by the Consumer or a third party authorised to act for the consumer in
transit from the Sellers store to the Consumer.
6. In order to make a claim under the Warranty, the Owner must, where possible return the goods to
the Seller’s store at the Owner’s cost. Proof of purchase must be supplied in all cases.
Tauris

7. The seller will examine any returned Products and if the Seller determines that there is an apparent
defect through no fault of the Owner, the Seller will:
a.) Make note of the Owner’s contact details including the Owner’s telephone number which the
owner can be contacted during business hours, postal address and e-mail address.
b.) Make note of the defects reported by the Owner.
c.) Take back the defec ve goods from the owner and determine within a reasonable me through
dialogue with the Seller whether the goods are defec ve.
d.) Advise the owner within a reasonable me frame whether it accepts or rejects the Product claim.
e.) If the Seller accepts the return of the Product, the Seller must arrange to have
i) The Product repaired or,
ii) Replace the damaged or faulty Product or,
iii) Refund the purchase price.
8. The Seller will not accept any returned Product which has not been returned strictly in accordance with
this Warranty.
9. For the purpose of this Warranty:
a.) Australian Consumer Law means the law as set out in Schedule 2 of the Compe on and Consumer
Act 2010 (Cth).
b.) Consumer means the Purchaser of goods from the seller.
c.) Consumer means a Consumer as that term is set out in sec on 3 of the Australian Consumer Law.
d.) Consumer Guarantees means the guarantees under the Australian Consumer Law.
e.) Implied terms means any guarantees, condi ons, warran es or other terms implied by any
Australian Commonwealth, State or Territory laws, (excluding the Australian Consumer Law) or the
law of any other jurisdic on.
f.) Owner has the meaning set out in clause 3.
g.) Warranty means this warranty.
h.) Product means the Product/s bought by the Owner from the Seller that fall under this warranty.
i.) Warranty Period means:
i) In rela on to Furniture: 12 months Limited Warranty.