tbs electronics 2650 User manual

www.tbsdtv.com
1
TBS2650 HDMI Video Encoder User Manual
1.Connections:
Prepare a Gigabit and multi-port Network Switch, connect Encoder all 4 Ethernet ports to the
Network Switch.
Power connection:
Connect AC power to Encoder device and then switch the button to “I”, then Encoder will start to
run. Button “I”means Encoder will be “power on”, button “O”means Encoder will be “power
off”:
2.IP definition:
1>Encoder has 4 Ethernet ports, and each Ethernet for 5 HMDI channels.
2>Each Ethernet we pre-configured a static IP. Once you access to web Interface, you can set a
new IP for your Encoder (IP information is marked on a small label):
Eth ○
1: IP is 192.168.1.217; Eth ○ 2: IP is 192.168.1.218;
Eth ○
3: IP is 192.168.1.219; Eth ○ 4: IP IS 192.168.1.220:
3>If you forget the IP, you can reset Encoder. After reset, IP will back to the default 192.168.1.217.
And of course, all 4 IP will back to default 192.168.1.217.
Reset:
Press and hold the “reset”button around 7 seconds, then IP will be reset to the default.
4>it means you should open 4 web Interface to configure.
5>web Interface login: username/password is: admin/admin
○
1:192.168.1.217
○
2:192.168.1.218
○
3:192.168.1.219
○
4:192.168.1.220

www.tbsdtv.com
2
3.Configuration:
Encoder TBS2650 configuration is same as TBS2605, more details please refer to TBS2605 User
Manual to configure (TBS2650 is consisted by 4 pieces TBS2605):
http://www.tbsiptv.com/download/tbs2605/tbs2605_user_guide.pdf
https://www.tbsiptv.com/index.php?route=product/download/drivers&path=download/tbs2605
/tbs2605_data_sheet.pdf&id=122
Any questions or any doubts, please write to us:
[e-mail]