Quick Start Guide
(1) STORE/LEVEL switches – Briey ip the switch up to store the current loop as
a backing track, or hold up for 3 seconds to delete stored backing track. Hold the
switch in the down position while turning the associated LOOP knob to adjust the
level of the backing track.
(2) LOOP knobs – Adjust the level of a loop or backing track.
(3) SERIAL/SYNC switch – When set to Serial, either loop 1 or 2 can be played
at a time. In Sync mode, both loops can be played simultaneously.
(4) DECAY knob – Controls the amount of volume reduction that occurs each time
an overdub repeats.
(5) FX knob – Selects one of the 7 FX options.
(6) LOOP 1 and 2 footswitches – Use these to control several loop-related
functions. (see reverse side)
(7) STOP footswitch – Press to stop both loops immediately.
Hold to erase the loops.
(8) FX footswitch – Press to engage the selected loop FX.
DITTO X4 LOOPER
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be suered by any person who relies
either wholly or in part upon any description, photograph, or statement contained herein.
Technical specications, appearances and other information are subject to change without notice.
All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake,
Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera and Coolaudio are trademarks
or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd.
2019 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding
Music Tribe’s Limited Warranty, please see complete details online at musictribe.com/warranty.
Zhongshan Eurotec Electronics Limited
No. 10 Wanmei Road, South China Modern Chinese Medicine Park, Nanlang Town,
528451, Zhongshan City, Guangdong Province, China
Simple and Intuitive Dual-Track Guitar Looper Pedal with Powerful Loop Eects
(9) INPUT jacks – Connect one ¼" TS cable for mono operation,
or 2 cables for stereo.
(10) OUTPUT jacks – Send audio via one or two ¼" TS cables.
(11) Power input – Connect the 9V power supply. (9 V DC, >300 mA)
(12) MODE switches – Adjust ne details of pedal’s operation.
See the full manual for details.
(13) USB input – Connect to a computer to transfer les back and forth,
and for rmware updates.
(14) MIDI jacks – Allows connection of an external MIDI clock,
and program and CC changes from a MIDI controller.
IMPORTANT SAFETY INSTRUCTION
Before operating the device, please see “Important Safety Instructions”
on page 3 of the full manual.
Visit tcelectronic.com to download the full manual
(1)
(2) (3) (4) (5)
(6) (7) (8)
(9) (10) (11) (12) (13) (14)
