TeacherGeek Wind Turbine Stand User manual

WIND TURBINE STAND - BUILD
Page 1
Materials Required:
Part
Quantity
¼” Wing Nut
1
T-Plate
2
¼” Lock Nut
4
¼” 1 ¼” Screw
4
Stand Base
1
Stand Upright
1
Tools Required:
Straight Screwdriver
7/16”Wrench or Pliers

WIND TURBINE STAND - BUILD
Page 2
Step #1:
Attach the two T-plates to the base of the stand using 2 screws and locking nuts.
Use these holes in the base.
Your wind stand base may not
have the center hole.
Upright
Stand Base
Lock Nuts
and Screws
Wing Nut
and Screw
Base

WIND TURBINE STAND - BUILD
Page 3
Step #2:
Attach the upright to the T-plates using 2 screws. Place a lock nut on the bottom screw and a
wing nut on the top screw. Tighten the lock nuts and wing nut.
Your turbine stand is done!
Lock Nuts and Screws
Wing Nut and Screw
T-Plates

WIND TURBINE STAND - BUILD
Page 4
You can now attach your geared or direct drive turbines.
Folding the stand down:
The upright on your stand can be folded down for storage.
a. Unscrew the wing nut.
b. Remove the loose screw (the screw the wing nut attached to).
c. Fold the upright down.